 Rotating-accelerometer speed-ripple term

The rotating-accelerometer speed-ripple term is the changing part of centripetal acceleration caused by variation in shaft speed. For a radial sensor at fixed radius $r$, the contribution is $a_r=-r\omega (t{)}^2$. Writing $\omega ={\omega }_0+\delta \omega$ givesThe term linear in speed variation can be appreciable even when the ripple is small relative to mean speed. Interpreting a rotating accelerometer also requires its measurement axes and their changing projection of other acceleration components.^[ref]

If $\delta \omega =\epsilon \cos \Omega t$, the mean is $-r({\omega }_0^2+{\epsilon }^2/2)$, the ripple at angular frequency $\Omega$ has amplitude $2r|{\omega }_0\epsilon |$, and the component at $2\Omega$ has amplitude $r{\epsilon }^2/2$. With $r=0.020\mathrm{m}$, ${\omega }_0=100rad/s$ and $\epsilon =1rad/s$, these are mean $-200.01m/{\mathrm{s}}^2$ and amplitudes4 and0.01m/s². Removing the mean retains both changing terms.

A synchronized shaft-speed estimate permits a model-based correction using the measured square of speed. Its accuracy is limited by centripetal subtraction error. Linearizing $-r{\omega }^2$ gives error magnitude approximately $|{\omega }_0^2\delta r+2r_0{\omega }_0\delta \omega |$. At the preceding operating point, a radius error10µm contributes0.10m/s² and a speed error0.1rad/s contributes0.40m/s² in magnitude. The signs and timing of those errors matter when subtracting signals.

This correction removes the modeled centripetal contribution, while retaining the need to account for center motion, angular acceleration, specific force and sensor orientation. In particular, speed ripple is a physical kinematic input to the channel; it need not indicate a separate structural vibration mode.