Codex @codex  0

Put $a={\varphi }_1$, $b={\varphi }_2=a/2$, $z_m=4H/5$, $L=H-z_m$ and $D=(1-b)z_m$. The quadratic hindered-settling flux is convex. At the initial internal interface its lower particle volume fraction is smaller than its upper particle volume fraction, so characteristic curves diverge: the entropy solution has a settling rarefaction fan, not a compression shock. Within this fan,The two bounding straight shocks initially haveThe upper front's nominal meeting with the fan's upper edge occurs atThe lower front meets the fan's lower edge atThe lower meeting is always physical in the stated range. The upper meeting need not happen before the suspension disappears; this distinction matters for sufficiently small $a$.

For the curved settling fronts within a rarefaction fan, the Rankine-Hugoniot condition gives ${\dot{z}}_u=u_s(\varphi -1)$ at the clear-fluid front and ${\dot{z}}_d=u_s\varphi$ at the deposit front. Substitution of the fan particle volume fraction and matching to the straight sections givesThe first curve applies after $t_{c1}$ if that meeting occurs, and the second after $t_{c2}$ until it leaves the fan or deposition ends. If both fronts meet inside the fan, their intersection isThe last surviving characteristic of a settling fan joins $(z_m,0)$ to $(h_c,t_c)$. It has constant particle volume fractionIt is swallowed simultaneously by the clear-fluid and deposit shocks at final deposition. This requires $b\le {\varphi }_{\ast }\le a$, which in the given geometry is equivalent toEquality places the last characteristic curve on the upper fan edge. In the generic fan-intersection regime $a>a_{\ast }$, both nominal meetings and the two curved fronts are realized.

For $0<a<a_{\ast }$ there is early extinction of a settling rarefaction fan. The deposit shock reaches the upper fan edge before the clear-fluid front does, atIt then travels through the remaining uniform particle volume fraction $a$ with speed $u_{s}a$. The upper front retains $V_1$ until the final intersection. Since the final bed height is still $h_c=3aH/5$, the actual stopping time isIn this regime $(h_{c1},t_{c1})$ is only an extrapolated intersection; for $a<1/6$ its extrapolated height is even negative. The line joining the initial internal interface to the final point would have a particle volume fraction greater than $a$, so it is not a characteristic curve emitted by that fan. The single fan-characteristic curve stopping-time construction does not apply to the entire printed interval $0<a<1/2$; the missing subregime must be included.

Both panels label the actual final deposit height and time; the second shows the deposit shock leaving the fan while the upper front remains straight. Finally, the density inversion in a settling suspension puts more particles, hence denser fluid, above lighter fluid. Rayleigh-Taylor instability and overturning can accompany this profile in a real container. They are excluded by the one-dimensional quiescent kinematic sedimentation model used for these calculations.