General information: Micro Bit v1
The file:
/media/$USER/MICROBIT/DETAILS.TXT
contains:
DAPLink Firmware - see https://mbed.com/daplink
Version: 0234
Build:   Oct 12 2015 14:53:22
2022-10-14: stopped being able to connect to Ubuntu 22.04. Was trying to do a UART video demo, connected USB, disconnected, connected, disconnected several times on different filming attempts. Was working some of the time, Ubuntu did recognize it, I even saw UART output for sure, but was a bit unstable. But then at one point it just stopped getting recognized by Ubuntu 100% of the time. The board is still being powered by USB, and the previously flashed program still runs, but nothing showed on sudo dmesg -w at all, and I can't reprogram it!
A day later, managed to get tit to connect once more with a different cable, but just once!
[15310.385055] usb 1-5: new full-speed USB device number 38 using xhci_hcd
[15310.534996] usb 1-5: New USB device found, idVendor=0d28, idProduct=0204, bcdDevice=10.00
[15310.535000] usb 1-5: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[15310.535001] usb 1-5: Product: MBED CMSIS-DAP
[15310.535002] usb 1-5: Manufacturer: MBED
[15310.535003] usb 1-5: SerialNumber: 9900023436424e45001d30150000005d00000000cb8928bd
[15310.541267] usb-storage 1-5:1.0: USB Mass Storage device detected
[15310.541643] scsi host4: usb-storage 1-5:1.0
[15310.542658] hid-generic 0003:0D28:0204.000A: hiddev1,hidraw2: USB HID v1.00 Device [MBED MBED CMSIS-DAP] on usb-0000:00:14.0-5/input3
[15310.543121] cdc_acm 1-5:1.1: ttyACM0: USB ACM device
[15311.549969] scsi 4:0:0:0: Direct-Access     MBED     DAPLINK VFS      0.1  PQ: 0 ANSI: 2
[15311.550273] scsi 4:0:0:0: Attached scsi generic sg1 type 0
[15311.550825] sd 4:0:0:0: [sdb] 16512 512-byte logical blocks: (8.45 MB/8.06 MiB)
[15311.551052] sd 4:0:0:0: [sdb] Write Protect is off
[15311.551054] sd 4:0:0:0: [sdb] Mode Sense: 03 00 00 00
[15311.551204] sd 4:0:0:0: [sdb] No Caching mode page found
[15311.551207] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[15311.572160] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[15316.317438] usb 1-5: reset full-speed USB device number 38 using xhci_hcd
[15316.445093] usb 1-5: device descriptor read/64, error -71
[15316.681102] usb 1-5: device descriptor read/64, error -71
[15316.917102] usb 1-5: reset full-speed USB device number 38 using xhci_hcd
[15317.045028] usb 1-5: device descriptor read/64, error -71
[15317.281149] usb 1-5: device descriptor read/64, error -71
[15317.517154] usb 1-5: reset full-speed USB device number 38 using xhci_hcd
[15317.517466] usb 1-5: Device not responding to setup address.
[15317.725358] usb 1-5: Device not responding to setup address.
[15317.933042] usb 1-5: device not accepting address 38, error -71
[15318.061027] usb 1-5: reset full-speed USB device number 38 using xhci_hcd
[15318.061347] usb 1-5: Device not responding to setup address.
[15318.269270] usb 1-5: Device not responding to setup address.
[15318.477018] usb 1-5: device not accepting address 38, error -71
[15318.477153] usb 1-5: USB disconnect, device number 38
[15318.652912] usb 1-5: new full-speed USB device number 39 using xhci_hcd
[15318.785044] usb 1-5: device descriptor read/64, error -71
[15319.021068] usb 1-5: device descriptor read/64, error -71
[15319.257030] usb 1-5: new full-speed USB device number 40 using xhci_hcd
[15319.385075] usb 1-5: device descriptor read/64, error -71
[15319.621147] usb 1-5: device descriptor read/64, error -71
[15319.729170] usb usb1-port5: attempt power cycle
[15320.384941] usb 1-5: new full-speed USB device number 41 using xhci_hcd
[15320.385176] usb 1-5: Device not responding to setup address.
[15320.593188] usb 1-5: Device not responding to setup address.
[15320.801023] usb 1-5: device not accepting address 41, error -71
[15320.928909] usb 1-5: new full-speed USB device number 42 using xhci_hcd
[15320.929073] usb 1-5: Device not responding to setup address.
[15321.137244] usb 1-5: Device not responding to setup address.
[15321.344947] usb 1-5: device not accepting address 42, error -71
[15321.345173] usb usb1-port5: unable to enumerate USB device
[15321.384929] FAT-fs (sdb): unable to read boot sector to mark fs as dirty
Exact same USB and port could still mount the Raspberry Pi Pico.

Articles by others on the same topic (0)

There are currently no matching articles.