Frequency modulation laboratory

The New Jersey Institute of Technology's Lab 2: FM Modulation, Demodulation and Bessel Zeros, Part I, prepares a voltage-controlled oscillator in low-frequency mode. A frequency counter reads its output while a buffered constant electric potential difference calibrates its sensitivity. Sweeping the control voltage checks linearity; the calibrated gain is then held fixed.^[ref]

An audio oscillator replaces the constant control voltage. An oscilloscope displays the signal and its FFT frequency spectrum together. Zero modulation supplies a carrier reference. Increasing message amplitude reveals sidebands, compares their heights with the carrier, and locates a carrier minimum. These readouts test the spectrum and infer frequency deviation. This is a student procedure, not a report of measured results.^[ref]

A carrier minimum is a minimum of one Fourier coefficient, not disappearance of the whole signal. In the ideal model the first positive zero of $J_0$ is approximately $\beta =2.4048256$, while the wave envelope remains $A$. The lab's introductory special-cases paragraph agrees with this rounded value; step T12 mistakenly repeats the equal-sideband value for the carrier zero.^[ref]

The interpretation also has practical limits. A finite recording limits frequency resolution; inadequate sampling can cause aliasing; and nonlinear VCO response can introduce extra components. Keeping the gain fixed and first checking linearity helps distinguish those effects from a change in FM modulation index. The diagrams above are independent model calculations, not laboratory measurements.