Curved settling fronts within a rarefaction fan Created 2026-10-06 Updated 2026-11-05
For the quadratic hindered-settling flux, let the initial normalized concentration be below and above it, within a column . The internal settling rarefaction fan has
Before entering the fan, the upper clearing front follows and the lower deposition front follows . They reach the fan at respective times and .
Inside the fan, the Rankine-Hugoniot condition gives
Integrating these linear ordinary differential equations and matching to the entry events yields
where and . Each curve applies only after that front enters the fan and while its adjacent concentration lies between and . If a front leaves the fan, its subsequent speed is set by the uniform state it encounters, rather than by extrapolating these curves.
Early extinction of a settling rarefaction fan Created 2026-10-06 Updated 2026-11-05
Consider normalized initial concentration above and below it, with , in the quadratic hindered-settling flux model. The final packed height is . The last surviving characteristic of a settling fan lies inside the fan only if
The upper inequality gives ; the lower gives . Thus both front curves can be used through the final meeting only for .
If , the deposition front leaves the fan through its upper edge before meeting the clearing front. It then travels through uniform concentration at speed ; the clearing front stays straight. If , the clearing front instead leaves the lower edge first, while the deposition front stays at speed . Matching the appropriate straight and curved pieces gives
The expressions agree at the transition values. The bounds prevent an algebraic intersection of extrapolated curves from being mistaken for a physical meeting inside the settling rarefaction fan.
Put , , , and . The quadratic hindered-settling flux is convex. At the initial internal interface its lower particle volume fraction is smaller than its upper particle volume fraction, so characteristic curves diverge: the entropy solution has a settling rarefaction fan, not a compression shock. Within this fan,
The two bounding straight shocks initially have
The upper front's nominal meeting with the fan's upper edge occurs at
The lower front meets the fan's lower edge at
The lower meeting is always physical in the stated range. The upper meeting need not happen before the suspension disappears; this distinction matters for sufficiently small .
For the curved settling fronts within a rarefaction fan, the Rankine-Hugoniot condition gives at the clear-fluid front and at the deposit front. Substitution of the fan particle volume fraction and matching to the straight sections gives
The first curve applies after if that meeting occurs, and the second after until it leaves the fan or deposition ends. If both fronts meet inside the fan, their intersection is
The last surviving characteristic of a settling fan joins to . It has constant particle volume fraction
It is swallowed simultaneously by the clear-fluid and deposit shocks at final deposition. This requires , which in the given geometry is equivalent to
Equality places the last characteristic curve on the upper fan edge. In the generic fan-intersection regime , both nominal meetings and the two curved fronts are realized.
For there is early extinction of a settling rarefaction fan. The deposit shock reaches the upper fan edge before the clear-fluid front does, at
It then travels through the remaining uniform particle volume fraction with speed . The upper front retains until the final intersection. Since the final bed height is still , the actual stopping time is
In this regime is only an extrapolated intersection; for its extrapolated height is even negative. The line joining the initial internal interface to the final point would have a particle volume fraction greater than , so it is not a characteristic curve emitted by that fan. The single fan-characteristic curve stopping-time construction does not apply to the entire printed interval ; the missing subregime must be included.
Figure 1.
Settling rarefaction fan with curved fronts, and the small-concentration regime where the fan disappears early
. Details.
Both panels label the actual final deposit height and time; the second shows the deposit shock leaving the fan while the upper front remains straight. Finally, the density inversion in a settling suspension puts more particles, hence denser fluid, above lighter fluid. Rayleigh-Taylor instability and overturning can accompany this profile in a real container. They are excluded by the one-dimensional quiescent kinematic sedimentation model used for these calculations.