 Bearing thermal stiffness identification

Bearing thermal stiffness identification uses measured force changes along a specified thermal path, together with independently known expansion behavior, to infer the axial restraint of an assembly. The observed bearing thermal reaction slope is $q=dF/dT$ inN/K. Mechanical stiffness is force per displacement, so converting $q$ into stiffness requires the free relative-expansion rate $\beta$ in displacement per temperature. In the constant-compliance engaged model,Here $C_b$ and $C_s$ represent the bearing and supporting structure's axial mechanical compliance contributions.

For an original identification example, suppose equilibrated engaged measurements give forces160,320 and480N at temperature increases50,60 and70K. A linear regression gives slope16N/K and, within this model, an extrapolated zero-force engagement increase of40K. If an independent free-expansion measurement gives $\beta =2\mu m/K$, the total compliance is $0.125\mu m/N$ and total stiffness is $8N/\mu \mathrm{m}=8\times 10^{6}N/m$. A16N/K thermal slope is therefore not itself a16N/m spring stiffness.

The measurements have an identifiability limit: the slope determines $C_b+C_s$ when $\beta$ is known, rather than determining both contributions separately. A known supporting-structure compliance $C_s=0.100\mu m/N$ would imply $C_b=0.025\mu m/N$. Without that extra information, many pairs give the same total. If $\beta$ is also unknown, scaling both $\beta$ and total compliance by the same positive factor leaves the measured slope unchanged.

A bench experiment can measure axial force with a load cell, track shaft and housing temperatures, wait for equilibrated states and fit only measurements from the engaged regime. A separate low-restraint expansion measurement can estimate $\beta$. Repeating heating and cooling helps test whether friction, changing contact or thermal gradients invalidate the assumed single slope. These are proposed measurement steps, not a claimed manufacturer's experiment. The physical motivation is the need to accommodate relative thermal displacement in a locating/non-locating bearing arrangement.^[ref]

For independent $\beta$ and $q$, first-order propagation givesFor $\beta =2.0$ with standard uncertainty0.1µm/K and $q=16.0$ with standard uncertainty0.8N/K, the inferred total compliance has standard uncertainty about0.00884µm/N. Correlated temperature references require the corresponding covariance contribution rather than this independent-input expression.^[ref]