 Current-plane convention in heterodyne calibration

A current-plane convention in heterodyne calibration specifies which electrical current an inferred beat amplitude denotes: the detector's generated small-signal current, the current entering a cable, or the current dissipating power in a particular load. Those amplitudes need not be equal. A power-to-current conversion is meaningful only with its circuit and reference plane.

An original photodiode model uses generated peak-current phasor $I_d$, detector shunt admittance $Y_d$ and load impedance $Z_L$. Kirchhoff's current balance givesThe factor one half assumes peak phasors; with RMS phasors it disappears. The current in the load determines delivered electric power. The generated current is recovered only after correcting the current division and any intervening network.

For a resistive Norton model with source resistance and load resistance both $R$, $Y_d=1/R$, so $I_L=I_d/2$ and $P_L=|I_d{|}^{2}R/8$. If the source shunt admittance is negligible, $I_L\approx I_d$ instead. Calling both circuits “a detector feeding a 50-ohm instrument” does not establish the same current conversion.

Capacitive current division in heterodyne receivers adds frequency dependence. With $Y_d=i\omega C_d$ and resistive load $R$,For stipulated $C_d=1$ pF and $R=50\Omega$, this magnitude is approximately 0.9540 at 1 GHz and 0.3033 at 10 GHz. The same generated amplitude then gives a smaller measured load current at the higher frequency. These are equivalent-circuit calculations, not measured specifications of a particular photodiode.

NIST's primary optical-receiver experiment distinguishes microwave power delivered to a reference load from the power indicated by a sensor. It corrects sensor calibration, interconnecting-network loss and impedance mismatch using measured scattering and reflection parameters.^[ref] That apparatus makes the reference plane an experimental calibration choice rather than a label applied after analysis.

Document the detector model, load, frequency, cable and connector corrections, and peak-versus-root mean square convention before normalizing by separate arm currents. If the arm currents describe generated DC photocurrent while the beat numerator describes uncorrected load current, the resulting overlap includes electrical current division. Heterodyne amplitude-versus-power gain conversion and impedance matching address different parts of that chain and both may be needed.