 Gear base-roll speed

Gear base-roll speed $u_b$ is the rate at which base-circle rolling advances an ideal involute contact along the gear line of action. For a fixed-axis external pair at constant speed,The equality follows from the tooth-count speed ratio and compatible base pitches. It describes the rate of change of contact position along a geometric line, rather than the gear sliding velocity between material points on the flanks. Base circles and their common tangent define this geometry.^[ref]

For standard module2 gears with20 and40 teeth at20degree reference angle, base radii are $r_{b1}=20\cos 20{}^{\circ }\mathrm{mm}$ and $r_{b2}=40\cos 20{}^{\circ }\mathrm{mm}$. Signed angular velocities ${\omega }_1=50rad/s$ and ${\omega }_2=-25rad/s$ give the same $u_b\approx 0.93969m/s$. The first gear's reference-circle tangential speed is1m/s, so base-roll and pitch-circle speeds are distinct.

In one tooth-entry interval, the base circle advances one gear base pitch:With $f_m\approx 159.155\mathrm{Hz}$, the example advances5.90426mm per entry. An active contact length9.65457mm therefore gives gear contact duration $L/u_b\approx 10.2742\mathrm{ms}$.

For compatible involute teeth, changing center distance changes the operating pressure angle and operating pitch circles, while leaving the manufactured base circles unchanged. At the same shaft speeds, base-roll speed is therefore unchanged even though the usable contact length may change. This separates a kinematic rate from the active interval needed to calculate contact time. If speed varies, contact displacement follows $\int u_b(t)dt$; a constant-speed quotient is then only an approximation.