Gear contact duration ($T=L/u_b$)

Gear contact duration is the time for a specified tooth pair to traverse its active gear path of contact. For a fixed-axis external spur gear pair at constant speed, the contact location advances along the gear line of action at the common gear base-roll speedThis is the speed of the contact location along a geometric line, not the relative tooth-surface gear sliding velocity. The latter vanishes at the gear pitch point, while the contact location continues moving. For active path length $L$, duration is $T=L/u_b$. The geometry relates gear contact ratio to active path length divided by gear base pitch.^[ref]

The time between successive tooth-pair entries is $1/f_m$, with gear mesh frequency $f_m=N_1|{\omega }_1|/(2\pi )$. Since $r_{b1}=r_{w1}\cos {\alpha }_w$ for compatible operating geometry, the base-circle distance advanced per entry isConsequentlyA contact ratio above1 means one pair remains engaged after the next pair enters; it does not mean one pair contacts for an entire shaft revolution.

For the standard module2,20/40-tooth example with20degree reference angle, active length is9.65457mm and base pitch is5.90426mm. At driving angular velocity $50rad/s$, $u_b=0.93969m/s$, $f_m\approx 159.155\mathrm{Hz}$ and $T\approx 10.2742\mathrm{ms}$. The entry interval is6.28319ms, giving $T{f}_m\approx 1.63519$. Doubling both shaft speeds halves duration while preserving geometric gear contact ratio. Variable speed requires integrating the changing base-roll speed; a helical gear also needs a stated transverse slice or a whole-face contact convention.

Gear base-roll speed $u_b$ is the rate at which base-circle rolling advances an ideal involute contact along the gear line of action. For a fixed-axis external pair at constant speed,The equality follows from the tooth-count speed ratio and compatible base pitches. It describes the rate of change of contact position along a geometric line, rather than the gear sliding velocity between material points on the flanks. Base circles and their common tangent define this geometry.^[ref]

For standard module2 gears with20 and40 teeth at20degree reference angle, base radii are $r_{b1}=20\cos 20{}^{\circ }\mathrm{mm}$ and $r_{b2}=40\cos 20{}^{\circ }\mathrm{mm}$. Signed angular velocities ${\omega }_1=50rad/s$ and ${\omega }_2=-25rad/s$ give the same $u_b\approx 0.93969m/s$. The first gear's reference-circle tangential speed is1m/s, so base-roll and pitch-circle speeds are distinct.

In one tooth-entry interval, the base circle advances one gear base pitch:With $f_m\approx 159.155\mathrm{Hz}$, the example advances5.90426mm per entry. An active contact length9.65457mm therefore gives gear contact duration $L/u_b\approx 10.2742\mathrm{ms}$.

For compatible involute teeth, changing center distance changes the operating pressure angle and operating pitch circles, while leaving the manufactured base circles unchanged. At the same shaft speeds, base-roll speed is therefore unchanged even though the usable contact length may change. This separates a kinematic rate from the active interval needed to calculate contact time. If speed varies, contact displacement follows $\int u_b(t)dt$; a constant-speed quotient is then only an approximation.