 Gear sliding-friction loss

Gear sliding-friction loss is the rate at which relative tooth-flank sliding dissipates mechanical energy. In a simple Coulomb friction model with normal contact load $F_n$, coefficient of friction $\mu$ and gear sliding velocity $v_s$, the nonnegative dissipated power isThis is a local contact model, rather than the entire gearbox loss. Manufacturer guidance distinguishes gear-meshing losses from losses in rotating supports and warns that overall gear efficiency depends on load and speed.^[ref]

To derive the sign, let $v_s=v_1-v_2$ along the common tangent. The friction force on surface1 is $f_1=-\mu F_n\mathrm{sgn}(v_s)$ and that on surface2 is $-f_1$. Their combined mechanical power is $f_1{v}_1-f_1{v}_2=-\mu F_n|v_s|$. The corresponding positive quantity is the rate of mechanical energy loss. At zero sliding the ideal Coulomb sliding-loss term vanishes, even though another resistance mechanism can remain.

For a fixed-axis external spur gear pair with $|{\omega }_1|+|{\omega }_2|=75rad/s$, $|s|=4\mathrm{mm}$ gives $|v_s|=0.30m/s$. Hypothetical $\mu =0.05$ and $F_n=100\mathrm{N}$ give $P_f=1.5\mathrm{W}$. Holding these load and friction assumptions fixed while doubling both shaft speeds doubles the instantaneous loss at that geometric point.

Gear friction work per engagement integrates this varying loss through the active gear path of contact. If one pair carries a constant $F_n$, the contact coordinate runs from $-L_a$ to $L_r$ at constant speed $\dot{s}=u_b>0$, givingFor $L_a=5.0586\mathrm{mm}$, $L_r=4.5960\mathrm{mm}$ and $u_b=0.93969m/s$, the preceding loads and speeds give about $9.32\mathrm{mJ}$. Real tooth pairs share varying loads; an overall loss calculation must sum the applicable contacts and integrate their actual loads, sliding and friction model.