 Multiwire proportional chamber experiment

The original apparatus used $40\mu \mathrm{m}$ stainless-steel wires between meshes $7.5\mathrm{mm}$ away, flowing argon with organic vapor, negative mesh voltage and individual electronic amplifiers. A $5.9\mathrm{keV}$ X-ray source calibrated pulse height while voltage was varied.^[ref]

A coincidence circuit defined a narrow proton or pion beam. Scanning it across wires tested localization; the response edge matched the beam width, limiting the inference. Distant counts were attributed to accidental coincidences. Separate Electron scans measured pulse delay versus position, comparing gas mixtures and pulse-height-dependent electronics.^[ref]

Thresholds rejected small pulses, reducing detection efficiency. Wire-independence tests did not establish unlimited separation of overlapping tracks.^[ref]