 Solution

For the ray sketches in (i) and (ii), take a horizontally layered isotropic medium, a surface source and receiver, depth $z$ positive downwards, and wave speed $v(z)$. Snell's law conserves $p=\sin i/v$, where $i$ is measured from the vertical. A returning diving ray turns where $pv(z_t)=1$, withFor a uniform positive gradient $v=v_s+\beta z$, rays are circular arcs andThus ordinary travel time increases with distance but has a decreasing slope as deeper rays sample faster material. The following two leaves discuss the labelled changes to this reference structure.

For the OR alternative, the supplied fault-plane diagrams, assume the usual convention that shaded quadrants are compressional first motions on a lower-hemisphere projection. Each pair of nodal planes represents a fault plane and an auxiliary plane; first-motion polarity alone cannot choose which slipped. Geological mapping, aftershock locations or rupture observations can resolve that ambiguity.^[ref]

Diagram (i): normal faulting. The central unshaded band indicates the extensional dip-slip pattern. It is compatible with crustal extension, such as a continental rift or a spreading environment, with a hanging wall moving down relative to the footwall on the actual fault. Its two curved nodal traces are the possible fault and auxiliary planes.

Diagram (ii): strike-slip faulting. The two straight nodal diameters divide four alternating quadrants, as expected for two vertical candidate planes. It is compatible with a transform plate boundary or continental shear zone. One candidate is right lateral and the conjugate is left lateral; polarity alone does not select the actual plane. Without a north arrow, geographical strikes cannot be assigned.

Diagram (iii): oblique-slip faulting with a reverse component. The off-centre nodal intersection and curved traces distinguish it from pure vertical strike slip, while shading through the centre indicates the reverse component under the stated convention. It is compatible with transpression, such as oblique convergence at a plate margin or a compressional strike-slip bend. Both strike-slip and dip-slip components are required; it is not merely a rotated pure strike-slip pattern. Exact strike, dip, rake, and slip-plane selection cannot be recovered numerically from this uncalibrated printed sketch. Reversing the shading convention would reverse the normal/reverse interpretation, so the convention is essential.