 Rotational order

A rotational order expresses a signal’s frequency relative to a specified reference shaft’s rotational frequency:Thus $q=1$ means one oscillation per reference revolution and $q=1/2$ means one oscillation per two reference revolutions. A rotational order is dimensionless and need not be an integer. It is especially useful when a machine changes speed: a shaft-synchronous feature can keep the same rotational order while moving through many frequencies in an ordinary frequency spectrum.^[ref]

The reference is essential. Suppose shaft A turns at $600\mathrm{rpm}=10\mathrm{Hz}$ and shaft B at $1500\mathrm{rpm}=25\mathrm{Hz}$. The same $100\mathrm{Hz}$ signal has rotational order $10$ relative to A and $4$ relative to B. Changing the reference has changed the dimensionless label, not the measured vibration. Likewise, a 24-tooth gear turning at $900\mathrm{rpm}$ has a gear mesh frequency of $24\times 15=360\mathrm{Hz}$. Its mating 8-tooth gear turns at $2700\mathrm{rpm}$, giving the same gear mesh frequency but rotational orders $24$ and $8$ relative to the two shafts.

For a component with unwrapped phase $\varphi (t)$ and reference angle $\theta (t)$, the instantaneous version iswhere the reference angular velocity is nonzero and both angles use the same units. A constant rotational order gives $\varphi (t)=q\theta (t)+{\varphi }_0$. This explains why angular resampling makes a speed-following component periodic as a function of shaft angle. A vibration fixed at $100\mathrm{Hz}$ instead changes from rotational order $10$ to $5$ when the reference shaft accelerates from $600$ to $1200\mathrm{rpm}$.

An order tracking measurement therefore pairs a vibration sensor, such as an accelerometer, with a shaft-angle or speed reference, such as a tachometer. An order peak identifies a speed relationship; it does not by itself establish which part is damaged. A resonance can greatly change the amplitude as speed changes even when the excitation’s rotational order stays fixed.