Before the unmodified low-permeability breakthrough, the only original-fluid discharge is from layer 2. Polymer raises its resistance, so its rate is never greater than at the same fixed pressure. Selective diversion therefore does not increase the instantaneous original-fluid discharge during this initial interval.
It can increase original-fluid production at a later specified time by delaying completion of the sweep. Let be the treated low-permeability breakthrough time. Integrating its interstitial velocity gives
whenever activated polymer occupies that layer for a positive time before breakthrough. For , the unmodified reservoir produces no original fluid, whereas the treated reservoir still produces . Thus the strategy can give greater original-fluid flux at a given time after unmodified breakthrough, through delayed sweep rather than increased absolute slow-layer flow. A sufficient activation condition is with a nonzero slug that has not already exited the slow layer. If polymer only affects layer 1 after its breakthrough and never affects layer 2 before its own breakthrough, this particular benefit does not occur. Integrated recovery over a chosen finite operating window must be distinguished from a comparison at one time.

Articles by others on the same topic (0)

There are currently no matching articles.