Timing-skew bound for a ratiometric measurement ($|\log (r/r_0)|\le K|\delta t|$)

A timing-skew bound for a ratiometric measurement limits the resistance-ratio error caused by sampling the signal and reference at different times. It converts a bound on the fractional rate of change of the shared excitation into an acquisition-timing requirement. This is useful even when the two analog filters are exactly matched.

Use the model in sampling skew after matched ratiometric filters: the common filtered excitation is $F(t)>0$, the true resistance ratio is $r_0=R_T/R_{\mathrm{ref}}$, and the reference is sampled $\delta t$ after the signal. Then $r/r_0=F(t)/F(t+\delta t)$. Suppose $F$ is continuously differentiable and its logarithmic derivative obeys $|F^{\prime }(s)/F(s)|\le K$ throughout the entire interval between the samples. The fundamental theorem of calculus givesThe same proof works for either sign of $\delta t$. Writing $\eta =K|\delta t|$, exponentiation yields the exact intervalThis is a deterministic bound under the stated slope assumption, rather than an expansion truncated at first order.

For an original timing budget, suppose $K=50{\mathrm{s}}^{-1}$ and require at most $0.1\%$ fractional resistance error from skew alone. It suffices to requireThe slightly smaller-than-$20\mu \mathrm{s}$ value accounts for the exponential upper bound. An excitation proportional to $e^{Ks}$ reaches one side of the logarithmic bound exactly, so the bound is attainable in this model.

A sufficient way to establish $K$ is to verify $F\ge F_{\min }>0$ and $|F^{\prime }|\le M$, giving $K=M/F_{\min }$. A filter cutoff by itself supplies neither a positive excitation floor nor this fractional-slope bound. Near an excitation zero, a small absolute change can produce a large resistance-ratio error. The primary filter-design report establishes the need to match signal and reference dynamics and to allow filter settling; the inequality above adds an original unequal-time error budget.^[ref]

A proposed bench check uses a stable sensor substitute and reference resistor, records the filtered excitation with an oscilloscope, and deliberately changes the acquisition delay. Compare each observed ratio with the interval predicted from a verified excitation floor and slope bound. This isolates timing effects from a fixed reference-resistor error in ratiometric resistance measurement.