 Gear face load distribution

Gear face load distribution describes how tooth-contact load is spread across the engaged gear face width. Equal total transmitted force can produce different local loads when shafts tilt, supports deform or tooth traces are imperfect. A geometrically available gear effective face width therefore does not establish uniform loading. The manufacturer's tooth-flank gear face load factor accounts for support arrangement and the expected quality of contact under load.^[ref]

For a simple axial line-load model, let $w(z)$ have units $N/mm$ over $0\le z\le b$. Its total normal force isUniform loading gives $w=F_n/b$. An illustrative tilted distribution isIts integral remains $F_n$, while its largest line load is $(1+\lambda )F_n/b$. With $F_n=1000\mathrm{N}$, $b=20\mathrm{mm}$ and $\lambda =0.6$, the two edges carry20 and80N/mm, compared with the50N/mm mean. The peak-to-mean ratio1.6 characterizes this constructed model; it is not a substitute for the manufacturer's standard factor calculation.

The gear contact pattern can reveal where mating tooth flanks touch, but an unloaded marking test alone does not measure the operating force density. A loaded comparison must specify applied torque, shaft positioning and support deformation. In helical gears, changing tooth-contact lines and multiple simultaneous contacts also require a consistent choice of time and projected width. A wider tooth can reduce mean load per width while still suffering a concentrated edge load; width and alignment must be considered together.