 Integrator reset

An integrator reset establishes the charge on an integrating amplifier's feedback capacitor before the next measurement. Without it, the next output includes the previous initial condition, and repeated input pulses or input offset voltage can eventually cause amplifier clipping. Resetting makes consecutive measurement intervals comparable; it does not reconstruct a pulse already lost to amplifier clipping.

Consider an inverting integrating amplifier with the input held at zero during reset. Place an analog switch across its feedback capacitor $C$. In the approximation of a stable ideal operational amplifier maintaining a virtual ground, a closed switch with constant on-state electrical resistance $R_{\mathrm{on}}$ gives the RC circuit relationThis exponential decay gives an integrator reset settling time for residual magnitude at most $\epsilon$:For stipulated values $C=10\mathrm{nF}$, $R_{\mathrm{on}}=10\mathrm{k\Omega }$ and $|V_{\mathrm{old}}|=0.50\mathrm{V}$, the reset time constant is $100\mu \mathrm{s}$. Reaching a residual of $1\mathrm{mV}$ requires about $621\mu \mathrm{s}$ in this model. Actual amplifier drive, stability and recovery from overload can change the response. A switch's control delay also differs from the full circuit's settling time.^[ref]

Opening the reset switch can itself disturb the initial condition. Analog switch charge injection transfers a small charge to the connected capacitor, producing a reset charge-injection pedestal of magnitudeFor a stipulated $10\mathrm{pC}$ deposited on $10\mathrm{nF}$, this step is $1\mathrm{mV}$. Its sign depends on the circuit and charge direction. A longer reset suppresses the preceding exponential residual but need not suppress the new step created when the switch opens. Analog Devices illustrates this capacitive coupling mechanism and the resulting output step separately from retained-charge settling.^[ref]

A practical experiment repeats zero-input measurements with several reset durations and reads the output at the same delay after switch opening. A decreasing residual indicates incomplete discharge; a persistent offset can instead include reset charge-injection pedestal, input offset voltage and subsequent drift. Repeated readings help separate the reproducible offset from noise. The ACF2101 provides a concrete historical implementation: separate hold and reset controls disconnect the input and discharge the integration capacitor, and its datasheet shows the sequence of hold, integration and reset states.^[ref]

The reset interval also creates integrator reset dead time: charge arriving while the circuit is being reset may not contribute to the next measured integral. Pulse timing relative to the reset therefore matters. A perfectly repeatable baseline alone does not establish that every input pulse was captured.