 Pressure-tap position error

A pressure-tap position error assigns a measured surface pressure to the wrong point on an airfoil. This differs from a pressure transducer's pressure-reading error: an accurate instrument can faithfully measure the pressure at a misplaced or incorrectly labeled hole. A steep spatial pressure gradient makes a small location error important.

Let $\xi =x/c$ be the nominal chord coordinate and let the actual pressure tapping lie at $\xi +\epsilon$. For a differentiable pressure coefficient profile,If the derivative is bounded by $K$ throughout the interval between the two positions, the mean value theorem gives the rigorous bound $|\delta C_p|\le K|\epsilon |$. Knowing only an endpoint slope does not establish that bound across an unresolved peak.

In an original local example, take $c=0.20\mathrm{m}$, a physical position error $\delta x=0.40\mathrm{mm}$, and a profile locally linear with $C_p^{\prime }=20$. Then $\epsilon =0.002$ and $\delta C_p=0.040$. At dynamic pressure $q=500\mathrm{Pa}$, the corresponding pressure difference is $q\delta C_p=20\mathrm{Pa}$. These are stipulated values illustrating sensitivity, not measurements of a particular airfoil.

For fixed quadrature weights $\mathbf{w}$ and small errors in several tap positions, put $J=\mathrm{diag}(C_p^{\prime }({\xi }_i))$. If ${\Sigma }_{\xi }$ is their position-error covariance matrix, the first-order variance contribution to a reconstructed coefficient isThis formula retains correlated position errors of pressure taps, including a shared coordinate-origin error. It holds the reconstruction weights and surface geometry fixed; uncertainty in those also needs accounting when geometry is inferred from the same coordinates.

Pressure-tap position calibration measures the actual hole coordinates and their reference origin, alongside pressure-channel calibration. Robert M. Pinkerton's distributed-pressure experiment used 54 orifices on an airfoil model to compare a measured distribution with potential flow predictions.^[ref] Such a comparison tests both where a feature occurs and how large it is; pressure-only calibration cannot fix a displaced coordinate.