 Pulse generator

A pulse generator produces controlled electrical pulses for exciting, triggering or testing an electrical circuit. The useful specification includes high and low levels, pulse width, repetition period, edge behavior and the timing relationship to a trigger. A repeating pulse train and a single triggered pulse impose different test conditions even when their individual pulse shapes agree.

For an original ideal train with low level zero, high level $V_p$, pulse width $\tau$ and period $T$, define duty cycle $D=\tau /T$ and repetition frequency $f=1/T$. Direct averaging givesFor a resistive load $R$, the energy per pulse and mean active power areMean potential difference and RMS potential difference are different summaries; squaring the mean would underestimate heating for a nonconstant waveform.

Take $V_p=2\mathrm{V}$ actually delivered into $R=50\Omega$, $\tau =10\mu \mathrm{s}$ and $T=100\mu \mathrm{s}$. Then $D=0.1$, $f=10\mathrm{kHz}$, mean potential difference is $0.2\mathrm{V}$, and RMS potential difference is about $0.6325\mathrm{V}$. The pulse deposits $0.8\mu \mathrm{J}$ and average load power is $8\mathrm{mW}$. These are stipulated rectangular-pulse values, not instrument limits.

Real pulse width needs a threshold definition. Keysight's primary control documentation measures it between the rising and falling 50% crossings and provides duty-cycle entry as an alternative.^[ref] Rise time, edge asymmetry and trigger timing must be measured or specified separately; a nominal width alone does not describe the full waveform.

Termination also changes what reaches the load. The existing Keysight documentation explains a fixed series output impedance and the difference between a selected load setting and the actual connected load. Its example gives twice the displayed amplitude at an open circuit when the display assumes a matched 50-ohm load.^[ref] Use the delivered pulse levels in the energy calculation.

A proposed test connects the intended termination, records the pulse at the load with an oscilloscope, and checks levels, crossing times and repetition intervals. Varying pulse width at fixed amplitude and repetition rate should change resistive average power in proportion to $\tau$ under the ideal model. Loading and finite edge durations explain departures that should not automatically be assigned to the programmed timing.