 Section lift-curve slope

The section lift-curve slope $a_0$ is the local derivative of a two-dimensional section lift coefficient with respect to its effective angle of attack, at stated flow conditions:The local linear approximation is $c_l\simeq a_0({\alpha }_{\mathrm{eff}}-{\alpha }_0)$, where ${\alpha }_0$ is the zero-lift angle of attack. Lifting-line theory uses this section relation while separately solving for the induced flow from the finite wing.^[ref]

The angle unit matters. In incompressible thin airfoil theory, the ideal slope is $2\pi$ per radian, or $2\pi (\pi /180)\simeq 0.1097$ per degree.^[ref] A tabulated slope of 0.10 per degree is about 5.73 per radian. Treating 0.10 as a per-radian value introduces a factor of about 57.3.

For an original section model with $a_0=6.0$ per radian and ${\alpha }_0=-2{}^{\circ }$, an effective incidence of $3{}^{\circ }$ givesThe relevant angular increment is five degrees, not three. With sectional dynamic pressure $q=500$ Pa and airfoil chord $c=0.30$ m, the resulting lift per unit span is $L^{\prime }=qc{c}_l\simeq 78.54$ N/m.

The finite-wing lift-curve slope is different because increased lift changes the downwash. For an ideal untwisted elliptic wing with uniform section slope, ${\alpha }_i=C_L/(\pi AR)$ givesTaking $a_0=2\pi$ and wing aspect ratio $AR=8$ yields $a\simeq 5.027$ per radian. This particular reduction is a consequence of the stated ideal loading, not a universal correction for arbitrary swept or separated wings.

A proposed wind tunnel measurement fits nearby section-force measurements against incidence while recording Reynolds number and Mach number. The fitted interval should remain within the approximately linear regime; aerodynamic stall can make one constant slope inadequate.