Conventional RF cavities accelerate beams with controlled phase, energy spread and transverse beam emittance. Their material surfaces limit sustainable gradients to order 10–100MVm−1, depending on technology and operating conditions. Mature RF systems already reached multi-GeV and much higher beam energies in 2015. The 2013 ILC baseline proposed 250GeV electrons colliding with 250GeV positrons, approximately 31.5MVm−1 superconducting cavities and a roughly 31km facility. These were design parameters, not an operating collider.[ref]
https://arxiv.org/abs/1306.6327. 2013 ILC Technical Design Report, Volume 1: baseline 500 GeV centre-of-mass design
In plasma wakefield acceleration, an intense laser displaces plasma electrons and excites a longitudinal charge-density wave. A suitably injected electron bunch gains energy from that wave, with fields of order tens to hundreds of GVm−1. A concrete result available before this examination was 4.2GeV from a 9cm capillary, with 6% rms energy spread, 6pC bunch charge and 0.3mrad rms divergence. These values characterize that experiment, not every laser-plasma beam; divergence alone is not an emittance measurement.[ref]
https://physics.aps.org/featured-article-pdf/10.1103/PhysRevLett.113.245002. 2014 experiment, abstract and first page: measured energy, spread, charge, divergence and capillary length
A collider concept stages many separately driven plasma modules, with fresh laser pulses, interstage capture and refocusing, controlled injection, and a final collision focus. Dephasing and pump depletion limit a single stage. Although the accelerating sections could be much shorter than ILC linacs, a useful collider also requires high repetition rate and wall-plug efficiency, reproducible low energy spread, preserved normalized emittance, stable timing, high bunch charge and acceptable beam-beam effects. Positron acceleration is an additional challenge because an electron-optimized plasma wake need not focus positrons. Large gradient alone does not demonstrate the luminosity or beam quality of an RF collider.
Ancestors (12)
- b
- 3
- S19
- 2015
- Past exam of the short options paper shared by Prelims and Parts A and B of the physics course of the University of Oxford
- Short options paper shared by Prelims and Parts A and B of the physics course of the University of Oxford
- Physics course of the University of Oxford
- Undergraduate course of the University of Oxford
- Course of the University of Oxford
- University of Oxford
- List of universities
- Home
Discussion (0)
New discussionThere are no discussions about this article yet.
Articles by others on the same topic (0)
There are currently no matching articles.