 Gear path of approach

The gear path of approach is the part of the active gear path of contact followed before the contact reaches the gear pitch point. For a conventional external involute pair in the stated driving direction, contact starts where the driven gear's tip circle intersects the usable gear line of action, and then moves toward the pitch point. This is a straight-line distance along the common normal, not an arc around a pitch circle.^[ref]

Let gear1 drive gear2. Write $r_{a2}$ for gear2's tip radius, $r_{b2}$ for its base radius, $r_{w2}$ for its operating radius and ${\alpha }_w$ for operating pressure angle. A right triangle from the base-circle tangency gives tip-to-tangency distance $\sqrt{r_{a2}^2-r_{b2}^2}$. Subtracting the pitch-point-to-tangency distance givesThis formula assumes the full tip-limited interval is usable without interference or profile truncation.

For an original standard module2,20/40-tooth pair at60mm center distance and20degree reference angle, gear2 has tip radius42mm, operating radius40mm and base radius $40\cos 20{}^{\circ }\mathrm{mm}$. Consequently $L_a\approx 5.0586\mathrm{mm}$. If gear1 rotates at $50rad/s$, contact advances along the line at $u_b=|{\omega }_1|r_{b1}=0.93969m/s$, giving an approach contribution to gear contact duration of about $5.383\mathrm{ms}$. This contact-location speed differs from gear sliding velocity, which tends to zero on arriving at the pitch point.

The total active length adds gear path of recess. Reversing the followed engagement direction exchanges which segment is called approach and which is recess. If altered usable flanks exclude the nominal pitch point, an assumed positive tip-limited formula must not replace an inspection of the actual active interval.