Gear path of recess

The gear path of recess is the part of the active gear path of contact followed after passing the gear pitch point, in the stated driving direction. For a standard external involute pair driven by gear1, contact ends at the driving gear's tip circle when that tip bounds the usable profile. The recess length lies on the gear line of action; it is not an arc of the gear pitch circle.^[ref]

Use driving-gear tip radius $r_{a1}$, base radius $r_{b1}$, operating radius $r_{w1}$ and operating pressure angle ${\alpha }_w$. The base-circle tangent triangle givesFor a standard module2,20/40-tooth pair at60mm separation and20degree reference angle, $r_{a1}=22\mathrm{mm}$, $r_{w1}=20\mathrm{mm}$ and $r_{b1}=20\cos 20{}^{\circ }\mathrm{mm}$ yield $L_r\approx 4.5960\mathrm{mm}$. The corresponding gear path of approach is about5.0586mm, so the pitch point does not bisect the active contact interval.

At driving angular velocity $50rad/s$, the contact-location speed is $u_b=|{\omega }_1|r_{b1}\approx 0.93969m/s$. Recess therefore lasts about4.891ms. Adding approach gives gear contact duration $T\approx 10.274\mathrm{ms}$. Tooth-passage frequency is $20(50)/(2\pi )\approx 159.155\mathrm{Hz}$, so $T{f}_m\approx 1.6352$, agreeing with the transverse gear contact ratio calculated as active length divided by gear base pitch.

A shorter usable driving flank reduces recess and can change gear sliding-friction loss, because sliding grows with distance from the pitch point. The tip-circle formula alone cannot describe profile modifications or an interfering contact. The geometry and direction must be specified before applying the approach/recess labels.