Model verification 2026-10-20
Assessing whether a computational implementation solves its specified equations or rules correctly.
Model validation 2026-10-20
Assessing whether a model is sufficiently consistent with independent observations for a specified scientific use. Validation has a domain of applicability and is not a proof of universal correctness.
Representing and propagating uncertainty in measurements, parameters, initial conditions and model structure into predictions.
Agent-based modeling Created 2026-10-20 Updated 2026-10-24
Modeling a system through interacting individual entities, such as cells, with rules for their states, behavior and environment.
Hardness 2026-10-20
Resistance to localized indentation or scratching; its measurement depends on the test geometry and load.
Toughness 2026-10-20
Capacity to absorb mechanical energy before fracture. Fracture toughness is a more specific measure of resistance to propagation of an existing crack.
Material selection Created 2026-10-20 Updated 2026-11-05
Material selection chooses materials by matching their properties and processing routes to a component's requirements. First exclude candidates violating constraints such as operating temperature, corrosion resistance or minimum stiffness, then compare a performance objective such as mass or cost. A tension member carrying force over length needs area at least , giving mass at least . Thus specific strength is relevant for this strength-limited case. A stiffness-limited beam can instead have a different material performance index, so there is no universally best lightweight material independent of geometry and loading.
Compressive strength 2026-10-20
A limiting compressive stress measured under specified conditions. Failure can involve yielding, crushing, splitting or instability; a slender specimen can buckle before its intrinsic compression limit is reached.
Tensile strength Created 2026-10-20 Updated 2026-11-05
The ultimate tensile strength in an ordinary tension test is the maximum applied tensile force divided by the specimen's original cross-sectional area:
It is the peak engineering stress, not necessarily the stress at final fracture and not the same as yield strength. A specimen with and peak load has tensile strength . Necking reduces the current area, so true stress using that area can behave differently after the engineering-stress peak. Temperature, loading rate and specimen preparation belong to the test conditions.[ref]
Mechanical fatigue 2026-10-20
Damage and possible failure under repeated loading, including crack initiation and growth at stresses below a single-load strength limit.
Creep (deformation) 2026-10-20
Time-dependent deformation under sustained mechanical load. Its rate depends on stress, temperature and microstructure.
Heat treatment 2026-10-20
Controlled heating, holding and cooling to change a material's microstructure and properties. Precipitation hardening and steel tempering are examples.
Ferroelectricity 2026-10-20
The existence of a spontaneous electric polarization that can be reversed by an applied electric field. A polar material is not necessarily switchable under useful conditions.
Thin film 2026-10-20
A material layer whose thickness is small relative to its lateral extent. Initial surface nucleation and later growth on the deposited material can obey different chemical conditions.
Nuclear materials 2026-10-20
Materials whose properties and performance are considered in a nuclear-energy or radiation environment. Radiation damage in materials, coolant compatibility and temperature-dependent properties are coupled to the component's mechanical function.

There are unlisted articles, also show them or only show them.