Make the code a leaf procedure called
array_diff, copy the four argument processor registers into the temporaries used above, and replace the final label by a return. The copies are real addu instructions, avoiding an unexplained move pseudo-instruction:array_diff:
addu $t0,$a0,$zero
addu $t1,$a1,$zero
addu $t2,$a2,$zero
addu $t3,$a3,$zero
# insert the code of (i), including its initial zero-count test
# use the local label array_diff_done in place of done
array_diff_done:
jr $ra
sll $zero,$zero,0In the literal insertion, the
done: line from (i) is the array_diff_done: line displayed here; it is not a second return block. Under the usual calling convention, temporary processor registers are caller-saved. This procedure calls no other procedure and changes no saved processor registers, so it needs no stack frame or saved return address.For a 32-bit constant , define and using its unsigned binary representation. Load it with
lui followed by ori; both are single MIPS instructions. For base addresses and count , the main program is:main:
lui $a0,H_A
ori $a0,$a0,L_A
lui $a1,H_B
ori $a1,$a1,L_B
lui $a2,H_C
ori $a2,$a2,L_C
lui $a3,H_N
ori $a3,$a3,L_N
jal array_diff
sll $zero,$zero,0
main_after_call:
# c now contains the differences; continue the main program hereHere each
H_... and L_... is an assembler-time numeric constant, not an executed operation. lui places the high half and clears the low half; ori inserts the low half without sign extension. ThusThe jal instruction saves the return address after its branch delay slot in $ra; jr $ra resumes at main_after_call. A main routine that itself needs to return to a caller must save its incoming $ra before jal and restore it afterwards. Articles by others on the same topic
There are currently no matching articles.