 Calibrated airspeed

Calibrated airspeed is indicated airspeed corrected for instrument and installation errors. It remains a pressure-based speed convention; correcting the indicator does not by itself convert the reading into true airspeed. The FAA uses an airspeed-calibration chart to distinguish the indicated and corrected values.^[ref]

Represent a specified correction chart byThe correction can depend on the operating condition. In an original invented chart, suppose indicated $20$ and $40m/s$ correspond to calibrated $22$ and $41m/s$. Linear interpolation over this stipulated interval givesso an indication of $30m/s$ maps to $31.5m/s$. Neither a constant $2m/s$ correction nor a universal percentage reproduces both chart endpoints. Extrapolation outside the measured interval is an additional assumption.

At low Mach number, corrected pressure difference is approximately ${\rho }_0{V}_{\mathrm{CAS}}^2/2$, with ${\rho }_0$ the standard reference air mass density. The example's corrected pressure estimate is $(31.5/30{)}^2=1.1025$ times the estimate obtained by treating the indication as calibrated. The corresponding correction to an inferred aerodynamic force at fixed coefficient and area is therefore not merely the $5\%$ speed correction.

Instrument testing checks the mapping from applied pressures to the reading. Installed-system work also addresses static-pressure position error: a port can sample a local pressure different from the intended free-stream static pressure. The correction must accompany its configuration and reference conditions. To obtain true airspeed, account for ambient conditions as well. At appreciable Mach number, compressibility also separates calibrated and equivalent airspeed; the low-speed square-root density conversion must not be silently extended to that regime.