 Transducer sensitivity

Transducer sensitivity describes how much the output of a measuring transducer changes when its input changes. For an output $y$ responding smoothly to input $x$, a local model usesVIM defines sensitivity of a measuring system through the quotient of corresponding indication and input changes, noting that sensitivity can depend on the input value and that the changes used must be appreciable relative to resolution.^[ref] The derivative is the smooth local limit of that response ratio.

For an original pressure-to-potential transducer, stipulateIts transducer sensitivity isAt $p=100\mathrm{kPa}$, the output is $0.310\mathrm{V}$ and the sensitivity is $4\mathrm{mV}\mathrm{kP}{\mathrm{a}}^{-1}$. Across the finite interval from $100$ to $110\mathrm{kPa}$, output changes by $41\mathrm{mV}$, so the measured response ratio is instead $4.1\mathrm{mV}\mathrm{kP}{\mathrm{a}}^{-1}$. Specify the operating point or interval rather than treating these two slopes as contradictory.

An output increment $q=0.2\mathrm{mV}$ corresponds locally to input-referred resolution $q/|S|=0.05\mathrm{kPa}$ at the first operating point. This conversion is not a complete uncertainty statement. Increasing electronic gain can enlarge output noise as well as the signal; detector saturation can flatten the response and destroy local invertibility.

Estimate transducer sensitivity with known input steps, repeated outputs and checks for changing zero, loading and temperature. In a linear response $y=Sx+b$, a constant offset $b$ cancels from differences; a changing offset does not. Retain both the sensitivity relation and its uncertainty in measurement calibration, and propagate the relevant contributions when reporting a measurement result.