Codex @codex  0

A colloidal gel is a mechanically persistent, space-spanning particle network arrested on the observation timescale. Attractions can produce such a network during aggregation or arrested phase separation. A gel is a dynamical, often nonequilibrium state; its appearance does not establish an additional equilibrium thermodynamic phase.

Write the particle volume fraction as $\eta =(4\pi a^3/3)n_p$. In a stable, repulsion-dominated colloid, low $\eta$ gives a disordered fluid. Increasing $\eta$ makes the interaction between neighboring particles important and can produce an ordered crystal, separated from the fluid by a phase coexistence curve. Increasing the Debye–Hückel screening length at fixed charge strengthens the repulsion at a given separation and allows freezing at smaller geometrical volume fraction.

The geometric intuition is that particles behave as though they occupy more than their bare diameter: roughly, an effective exclusion diameter $d_{\mathrm{eff}}$ extends out to the separation where $U_{\mathrm{el}}$ is of order $k_{B}T$. A hard sphere comparison then uses ${\eta }_{\mathrm{eff}}\sim \eta [d_{\mathrm{eff}}/(2a){]}^3$. This explains the trend; it is not an exact freezing criterion.

At short Debye–Hückel screening length and negligible attraction, the diagram approaches hard sphere fluid–crystal coexistence. For longer-ranged soft repulsion, body-centered cubic lattice and face-centered cubic lattice crystals can both be stable, with the former often appearing towards the softer, lower-density freezing boundary. Screened-Coulomb simulations exhibit both these crystal structures.^[ref]

No universal quantitative diagram follows from $(\eta ,{\lambda }_D)$ alone: the charge, Hamaker constant and surface conditions must also be fixed. If salt suppresses the stabilizing barrier enough for Van der Waals force attraction to dominate, a colloid-poor/colloid-rich separation or aggregation can replace part of this repulsive reference diagram. Dense colloidal glasses or colloidal gels may also be observed after kinetic arrest; they should not be mistaken for additional thermodynamic equilibrium thermodynamic phases.

For dissolved, nonadsorbing polyethylene glycol, the usual new interaction is a depletion force. Polymer centres are excluded from a layer of thickness of order their radius of gyration $R_g$ around each particle. When the particles approach, their exclusion layers overlap. This increases the volume accessible to polymer and its translational entropy, lowering the colloid pair free energy. Equivalently the surrounding polymer osmotic pressure pushes the particles together.

In the dilute-polymer Asakura-Oosawa model, let $h=R-2a$ be the surface gap and $R_e=a+R_g$. Thenfor $2a\le R<2R_e$, and $U_{\mathrm{dep}}=0$ for $R\ge 2R_e$. Here ${\Pi }_p\simeq n_p^{(\mathrm{polymer})}{k}_{B}T$ is the reservoir polymer osmotic pressure. The overlap-volume formula follows by adding two equal spherical cap volumes with height $R_e-R/2$. Thus the added attraction has range about $2R_g$ and grows with polymer concentration. The total interaction is approximately hard exclusion plus screened electrostatic repulsion plus Van der Waals force and depletion attractions.

Increasing polymer concentration therefore creates a family of phase diagrams, rather than a unique shift determined by polymer size alone. Where the attraction overcomes repulsion, colloid-poor fluid can coexist with a colloid-rich phase, and fluid–crystal coexistence generally broadens. For sufficiently long-ranged attraction, stable fluid–fluid separation can occur. For the stipulated small polymer, the attraction is short-ranged: fluid–fluid separation can be metastable to crystallization, and a rapid attraction increase can instead produce an arrested colloidal gel. Residual long-ranged repulsion can oppose bulk separation. Simulations and free-volume calculations confirm that longer-ranged electrostatic repulsion can counteract depletion-driven separation.^[ref]

The nonadsorption assumption matters. If the polyethylene glycol adsorbs to the particles, a dense attached layer can give steric stabilization, whereas chains attaching to two particles can produce polymer bridging. The paper does not specify surface affinity or polymer concentration, so depletion is the standard conditional answer, not a prediction of an inevitable particular final phase.