Solution

ID: past-exam-of-the-particle-astrophysics-course-of-the-university-of-cambridge/2013/paper-1/2/c/solution

A gravitational wave produces a time-dependent tidal distortion. For a normally incident plus-polarized wave in the long-wavelength limit, two perpendicular freely suspended arms change by and . Their differential length is therefore
for a simple round-trip Michelson interferometer. LIGO uses kilometre-scale orthogonal arms with optical cavities that enhance the phase response, a stabilized laser and suspended mirrors in vacuum. As an illustrative scale, across a 4 km arm corresponds to differential length . The measured quantity is returning light phase, not mirror displacement against a rigid external ruler. Optical storage and control loops give a frequency-dependent calibrated response.
Seismic and terrestrial disturbances dominate low frequencies, thermal motion of suspensions and mirror coatings contributes at intermediate frequencies, and photon shot noise limits high-frequency readout. Isolation and suspension systems reduce ground coupling; low-loss materials reduce thermal noise; vacuum suppresses gas scattering and forces. Greater optical power reduces shot noise but increases radiation-pressure fluctuations and thermal demands. Stable optical alignment and feedback are essential, yet their own sensor and actuator noise must be controlled. These are engineering requirements because the desired strain is extraordinarily small.[ref]
A candidate should appear coherently at separated observatories with consistent propagation delay and antenna response. Auxiliary environmental monitors, calibration injections and time-shifted coincidence backgrounds test instrumental explanations. Matched filtering is powerful for modelled compact-binary chirps; coherent burst searches allow less predictable signals. Binary-pulsar orbital energy loss already provided indirect evidence for gravitational radiation before 2013, but it is distinct from directly measuring passing waves.[ref] At the examination date, direct detection remained a search objective. Reliable detection requires both sufficient strain sensitivity and a demonstrated astrophysical signal rather than correlated or accidental noise.

New to topics? Read the docs here!