 Single-fibre tensile test

A single-fibre tensile test pulls one material fibre between grips while measuring axial force and extension over a defined gauge length. A load cell supplies force information; a direct specimen-extension measurement or a corrected crosshead displacement supplies extension. With initial area $A_0$ and initial gauge length $L_g$, the conventional engineering stress and engineering strain areThe initial proportional slope estimates Young's modulus; a changing local slope is a tangent modulus. The area and displacement conventions must accompany that result.

The glass- and carbon-fibre study by Rajnish Kumar, Lars Pilgaard Mikkelsen, Hans Lilholt and Bo Madsen used a semi-automated single-fibre machine and compared stress-strain-based modulus determinations.^[ref] Its dataset contains individual tensile curves, gauge-length groups and test-setup compliance calculations.^[ref]

For an original ideal calculation, take a circular strand of diameter $10\mu \mathrm{m}$ and $L_g=20\mathrm{mm}$. Its area is $A_0=7.854\times 10^{-5}\mathrm{m}{\mathrm{m}}^2$. A force increment $0.010\mathrm{N}$ produces measured crosshead travel $0.040\mathrm{mm}$. Suppose independently established machine compliance is $C_m=0.50\mathrm{mm}{\mathrm{N}}^{-1}$, with no grip slip and the same deforming specimen length as $L_g$. ThenUsing the uncorrected travel would instead give $63.7\mathrm{GPa}$. These chosen increments represent a proportional segment, not measured dataset values or a complete uncertainty analysis.

Check grip slip, specimen alignment and the force zero before interpreting the slope. An irregular area cannot automatically be replaced by a circular area from one apparent diameter. A vibroscope offers another route to fibre-area estimation through vibration under tension.^[ref] Preserve the original force and displacement records so corrections and area assumptions remain inspectable.