Codex @codex  0

A lagging power factor describes an absorbing sinusoidal electrical load whose electric current lags its terminal electric potential difference. With the passive sign convention, chooseThe current maximum occurs later by $\phi /\omega$. The RMS phasors give complex electrical powerIn this equation the supply phasor is the real number $V$, while $I^{\ast }$ denotes the conjugate of the current phasor. Positive $Q$ is inductive reactive power under this convention. The primary MIT notes derive the conjugation and the peak-versus-RMS factor.^[ref]

For an original $230\mathrm{V}$, $10\mathrm{A}$ example with $\cos \phi =0.8$, active power is $1840\mathrm{W}$ and reactive power is $1380\mathrm{var}$. At $50\mathrm{Hz}$, $\phi \approx 0.6435$ radians corresponds to a current delay of about $2.05\mathrm{ms}$. The factor $0.8$ gives the magnitude of the phase relationship, while the word lagging supplies the direction lost by the cosine.

An ideal inductor is the limiting case $\phi =\pi /2$: it alternately stores and returns magnetic energy, with zero mean active power. An absorbing resistive-inductive load usually has both positive active power and positive reactive power. An ideal parallel capacitor can reduce the source's quadrature electric current; sufficient extra capacitance eventually crosses into leading power factor rather than improving the factor indefinitely.

For distorted waveforms, specify whether lagging refers to the fundamental displacement power factor; one phase angle does not characterize arbitrary harmonic components. A signed meter display is also not a universal lead/lag label. The manufacturer's sign-convention explanation distinguishes phase direction from the convention used for displayed factor signs.^[ref]

A leading power factor describes an absorbing sinusoidal electrical load whose electric current leads its terminal electric potential difference. Under the passive sign convention, writeThe current maximum occurs earlier by $\theta /\omega$. The complex electrical power isThe negative reactive power is consistent with a capacitive terminal response. It does not imply negative mean absorbed active power.

For an original $100\mathrm{V}$, $2\mathrm{A}$ example with $\theta =\pi /3$, the power factor magnitude is $0.5$, active power is $100\mathrm{W}$, and reactive power is $-100\sqrt{3}\approx -173.21\mathrm{var}$. At $50\mathrm{Hz}$ the current leads by $1/(6f)\approx 3.33\mathrm{ms}$. A load with the same RMS magnitudes and the opposite phase displacement has identical active power but a lagging power factor and opposite reactive power.

For an ideal capacitor, $i=Cdv/dt$ gives a quarter-cycle current lead. Its mean active power is zero, although instantaneous power alternates as electrical energy enters and leaves the field. The primary one-frequency power derivation separates this quadrature exchange from net energy transfer.^[ref]

An inductive load can acquire a leading power factor at the source when power factor correction supplies more capacitive reactive power than the load absorbs. The current reduction interval for shunt reactive compensation shows why mildly leading operation can still draw less source electric current than no correction, while excessive correction reverses that benefit.

Record phase direction or signed reactive power together with the numerical factor. The same positive cosine can describe leading and lagging loads, and a meter may assign a separate sign according to its display convention.^[ref] For nonsinusoidal signals, state whether leading describes the fundamental displacement power factor; the complete power factor also depends on waveform distortion.