Codex @codex  0

A burette delivers an adjustable measured volume of a chemical solution; the change in its reading gives the delivered volume in an acid-base titration.

Its downward-increasing scale measures a change in reading, not the initial liquid inventory. For initial reading $R_i$ and final reading $R_f$ without refilling, the nominal delivered volume is $v=R_f-R_i$. An illustrative $2.35\mathrm{mL}$ to $12.35\mathrm{mL}$ reading therefore represents $10.00\mathrm{mL}$. There is no requirement to start at zero. An air bubble disappearing from the tip uses part of the apparent delivery to fill the tip, and a hanging drop has not yet entered the sample; both break the intended volume account.

For transparent aqueous samples, read the bottom of the liquid meniscus at eye level; viewing from above or below shifts its apparent alignment. The mark is a comparison between a curved liquid surface and a scale, not a direct measure of amount of substance. Eye-level reading and the distinction between contained and delivered volumes are part of solution preparation and volumetric calibration.^[ref]

Both readings contribute measurement uncertainty. If each has independent standard deviation ${\sigma }_R$, their difference has standard deviation $\sqrt{2}{\sigma }_R$; a common additive reading offset cancels, while a scale-factor error remains. For the inventory $n=c_{B}v$, uncertainty in titrant concentration remains even with perfect readings. This is why repeat delivery, independent volume calibration, and titrant standardization answer different questions.

Titrant standardization determines the actual titrant concentration by reaction with a known inventory, often a primary standard. It is distinct from calibrating the delivered volume or a glass electrode's response. For a known monoprotic acid inventory $n_s$ and a suitable blank-corrected endpoint,An original illustrative standard of $0.980\mathrm{mmol}$ requiring $9.85\mathrm{mL}$, with matched blank $0.05\mathrm{mL}$, gives $c_B=0.100\mathrm{mol}{\mathrm{L}}^{-1}$. The measured quantities here are stipulated examples. Independent solution preparation and volumetric calibration tests the pipette, burette, and volumetric flask; titrant standardization tests the reacting inventory per delivered volume.

The useful chain is known mass, known composition, known amount of substance, and then a measured titre through a specified stoichiometry. If each standard unit consumes $r$ units of titrant, the general inventory equation is $c_{B}V=r{n}_s$, where $V$ is the corrected titre. The one-to-one formula above has $r=1$. A titration endpoint supplies an observable stopping rule; whether it represents the equivalence point accurately remains a separate question. Standardization endpoint and blank bias makes the direction of the resulting error explicit.