Codex @codex  0

A liquid spreads macroscopically over a solid with zero macroscopic equilibrium contact angle. In the simple interfacial-energy model the threshold is ${\gamma }_{SV}-{\gamma }_{SL}={\gamma }_{LV}$, or zero spreading coefficient; positive coefficient favors a spreading film. Extrapolating a concentration-dependent liquid-vapour surface tension to this threshold assumes the other interfacial energies remain fixed and no intervening adsorption or micellization behavior changes the trend.

Molecular area from the adsorption slope. The supplied Gibbs adsorption equation identifies the surface excess number density $\Gamma =1/\Sigma$ throughThe logarithm is understood relative to a fixed concentration unit or reference concentration; only concentration ratios enter its differences. The pure-water point $c=0$ supplies a baseline surface tension, but cannot be included in $\ln c$.

An estimate near the later working concentration $0.055\mathrm{mol}\mathrm{d}{\mathrm{m}}^{-3}$ uses its two bracketing points:Taking room temperature as $298\mathrm{K}$,This corresponds to about $4.4$ adsorbed molecules per $\mathrm{n}{\mathrm{m}}^2$. The data are not perfectly linear in $\ln c$, so the inferred molecular area depends somewhat on the concentration range: a fit to all five positive-concentration points gives about $0.26\mathrm{n}{\mathrm{m}}^2$, while the higher-concentration region gives roughly $0.22\mathrm{n}{\mathrm{m}}^2$. An effective area of order $0.2$–$0.3\mathrm{n}{\mathrm{m}}^2$ is justified; a concentration-independent exact value is not.

Contact angle. Linear interpolation between $0.05$ and $0.06\mathrm{mol}\mathrm{d}{\mathrm{m}}^{-3}$ gives ${\gamma }_{LV}(0.055)=(48.5+45.2)/2=46.85\mathrm{mN}{\mathrm{m}}^{-1}$. For an ideal equilibrium contact angle measured through the liquid, Young's equation isThe supplied solid-vapour and solid-liquid values have difference $40\mathrm{mN}{\mathrm{m}}^{-1}$. HenceThis assumes clean homogeneous equilibrium interfaces, negligible contact-angle hysteresis, and the stated solid interfacial energies applicable to the solution.

Complete wetting. The spreading coefficient is $S={\gamma }_{SV}-{\gamma }_{SL}-{\gamma }_{LV}=40\mathrm{mN}{\mathrm{m}}^{-1}-{\gamma }_{LV}$. The onset of complete wetting occurs at $S=0$, or ${\gamma }_{LV}=40\mathrm{mN}{\mathrm{m}}^{-1}$, if the solid interfacial energies remain unchanged. The last measured value is still $42.0\mathrm{mN}{\mathrm{m}}^{-1}$, so this requires extrapolation beyond the table.

Continuing the last local slope in concentration, $(42.0-45.2)/(0.07-0.06)=-320\mathrm{mN}{\mathrm{m}}^{-1}$ per $\mathrm{mol}\mathrm{d}{\mathrm{m}}^{-3}$, givesContinuing a constant local Gibbs slope in $\ln c$ instead gives approximately $0.078\mathrm{mol}\mathrm{d}{\mathrm{m}}^{-3}$. Thus the data suggest a threshold near $0.08\mathrm{M}$ under continued-trend assumptions, rather than fixing one exactly. A surface-tension plateau caused by micellization, or a change in ${\gamma }_{SL}$, could prevent or shift this threshold; no such extra data are given.

Capillary rise. For a circular capillary of radius $a$, vertical surface-tension force $2\pi a{\gamma }_{LV}\cos \theta$ balances the weight $\rho g\pi a^{2}h$. Thus capillary action givesUsing $a=0.5\mathrm{mm}=5.0\times 10^{-4}\mathrm{m}$, $\rho =10^3\mathrm{kg}{\mathrm{m}}^{-3}$ and $g=9.81\mathrm{m}{\mathrm{s}}^{-2}$,This is the height above the reservoir level in the ideal static capillary approximation; meniscus-volume corrections and contact-angle hysteresis are neglected. The positive $\cos \theta$ gives a rise, rather than a depression.