Wing area ($S$)

The wing area $S$ is the area of an aircraft wing's projected wing planform. It is a reference area for such quantities as lift coefficient and wing aspect ratio. It is not the sum of the upper and lower curved surface areas.^[ref]

If the projected airfoil chord at spanwise position $y$ is $c(y)$, thenFor a symmetric trapezoidal wing planform this becomes twice the area under a linear half-wing chord distribution:With wingspan $b=10\mathrm{m}$, root chord $3\mathrm{m}$ and tip chord $1\mathrm{m}$, the result is $20{\mathrm{m}}^2$ for both halves together. Each half has area $10{\mathrm{m}}^2$. This factor of two matters when converting a half-wing drawing into a whole-wing reference area.^[ref]

The choice of reference area also affects reported coefficients. From $L=qS{C}_L$, where $q$ is dynamic pressure, a measured lift of $4000\mathrm{N}$ at $q=500\mathrm{Pa}$ and $S=20{\mathrm{m}}^2$ gives $C_L=0.4$. Using the half-wing area in that same whole-wing equation would incorrectly produce $C_L=0.8$. When comparing experiments or calculations, preserve the reference-area convention along with the measured force.

A wing sweep construction that shifts both projected edges aft by the same amount at each $y$ preserves $c(y)$ and therefore preserves wing area. The original comparison in wing planform illustrates this invariance. Changes to airfoil camber or thickness can likewise alter the three-dimensional surface and aerodynamic behavior without changing the projected outline.