 Winglet

A winglet is a small wing-tip lifting surface, often inclined upward out of the main wing planform. By changing the three-dimensional loading and flow near the tip, it can reduce lift-induced drag. Its winglet cant angle, shape and attachment must be considered with the entire aircraft wing; it is not a universal bolt-on reduction in total drag.^[ref]

Richard T. Whitcomb's 1976 report compared measured forces, moments and loads on a representative transport wing with and without wing-tip devices. A particularly useful comparison was a tip extension giving approximately the same increase of bending moment at the wing–fuselage junction as the winglets. That comparison asks how much aerodynamic benefit is obtained for a similar structural penalty, rather than comparing only nominal span.^[ref]

An original coefficient budget illustrates why component and total benefits differ. Keep the same reference wing area, dynamic pressure and lift coefficient. Suppose initiallywhere the second term is the lift-induced drag contribution. If a proposed modification reduces that term by $20\%$ but adds $0.001$ to other drag coefficient contributions, thenThe total reduction is about $3.33\%$, not $20\%$. This is an invented budget, not a prediction or a measured winglet efficiency. Increased loading, additional wetted area and an off-design operating point can change the result.

A convincing wind tunnel comparison measures total drag at matched lift, records moments and loading, and documents how the mounting correction and reference area are handled. A photograph of a weaker-looking wingtip vortex is not a measurement of total drag. Conversely, reducing lift-induced drag does not require all three-dimensional trailing vorticity to disappear.