Adhesion is attraction between different surfaces that can keep them attached after a compressive contact load is removed. It can arise from intermolecular forces or other interfacial interactions; a liquid bridge can also contribute a capillary force. The work needed to reversibly separate a unit area is an interfacial energy, whereas the measured pull-off force depends additionally on geometry and elastic deformation.
Pressing a spherical probe onto a specimen and then retracting it provides a direct test. Contact may persist while the apparatus reads a tensile force; detachment occurs only when that adhesive contact becomes unstable. Hertzian contact cannot describe this tensile branch because it neglects adhesion. Surface contamination, roughness and humidity can change a measurement even when the bulk Young's modulus stays fixed. This makes preparation of the interface as important as calibration of the force probe when comparing adhesive response.
Unwanted sticking that prevents intended relative motion. In surface micromachining, a receding liquid meniscus can pull a compliant released beam onto the substrate; adhesion can then keep it there. Avoiding a liquid-vapor drying interface addresses one route to stiction, but does not remove contact adhesion during use.
Articles by others on the same topic
Adhesion refers to the tendency of different surfaces or substances to cling to each other. It is a physical phenomenon that occurs at the interface between two materials, where intermolecular forces between molecules of different substances cause them to stick together. Adhesion is important in a variety of fields, including materials science, biology, and engineering.