Codex @codex  0

At a convergent margin, the incoming oceanic lithosphere is a chemically and mechanically layered package: sediments, oceanic crust and lithospheric mantle. Subduction does not deliver this whole package unchanged to one destination. Solids can be accreted, underplated, exhumed or recycled deeply, while released fluids and melts carry selected components to the overriding plate. The outcome depends on incoming composition and hydration, slab age, convergence rate, thermal structure, interface coupling and subsequent tectonic history.

The incoming material already contains a history. Sediments include terrigenous debris, biogenic carbonates, siliceous deposits, clay minerals, pore water and organic matter. Oceanic crust consists mainly of basalt, sheeted dikes and gabbro; hydrothermal alteration can add water, carbonates and mobile elements before subduction. Beneath it, residual peridotite forms the lithospheric mantle. Faulting at a spreading environment, a transform boundary or an outer-rise bending region can let seawater enter and cause serpentinization. The lithospheric mantle is not uniformly hydrated to its full thickness. Consequently, sediment thickness alone does not measure the incoming volatile inventory.

Sediments: separation starts near the trench. Compaction and increasing effective pressure expel pore fluids, which can escape through the forearc, transport dissolved constituents and influence pore pressure on the plate interface. Some sediments are scraped off into an accretionary prism, shortened by thrusts and retained in the upper plate. Others pass beneath the leading edge, then detach and undergo tectonic underplating beneath the forearc. Deeper underplated material may return to the surface during tectonic exhumation, preserving a record of burial and deformation. At a sediment-starved erosive margin, little prism may form, and tectonic erosion can entrain material from the overriding plate as well. Thus net continental gain and net continental loss are both possible; they can even alternate at one margin.

Sediments that remain attached to the slab undergo metamorphism, dehydration, and potentially decarbonation or carbonate dissolution. The released fluids can transport boron, barium, strontium, lead and other soluble constituents. Carbon can leave as dissolved species, remain in carbonate, or occur as reduced carbon depending on redox conditions and reaction history. Along sufficiently hot paths, sediment-derived melts or mixtures of sediment and altered rock can transfer material into the mantle wedge; buoyant mixed material may rise as a mélange diapir. Cold paths can instead retain more solid material and some volatile-bearing phases to greater depths. These are alternative reaction and transport pathways, not a single compulsory sequence. A carbon-budget study explicitly includes fluid dissolution, sediment diapirism and storage in the upper plate, showing why volcanic carbon dioxide alone cannot close the whole subduction carbon budget.^[ref]

Oceanic crust: metamorphic transformation and chemical filtration. Altered basalt and gabbro are progressively buried. Depending on their pressure-temperature paths and reaction kinetics, they can pass through blueschist facies or warmer assemblages and eventually form eclogite, dominated by garnet and omphacite. Eclogitization increases density and can strengthen negative slab buoyancy, but a kinetic delay can leave metastable rock. It is incorrect to assign every slab the same sequence or the same fixed depths for these changes.

During burial, breakdown of hydrous phases releases water-rich fluids; different mineral assemblages retain different quantities of water. The fluids migrate through or along the interface and into the mantle wedge, where they cause metasomatism and lower the solidus of peridotite. Flux melting of the mantle wedge generates much of the primary magma feeding a volcanic arc. This is different from saying that the entire descending oceanic crust melts beneath the arc. Most of its refractory mass can remain solid. Partial melting of oceanic crust is more plausible for unusually hot or young slabs, or other favorable thermal conditions, and produces a distinct crustal contribution.

The depth of dehydration is controlled by thermal structure and composition. Global thermal-petrological calculations, for example, predict more efficient deep water transport in old, fast, cold slabs than in hot ones, with substantial differences between volcanic crust, gabbro and hydrated peridotite. Such a calculation supports conditional deep retention; its modeled proportions should not be imposed on every margin.^[ref]

Mechanical detachment adds more branches. Upper-crustal slices, seamounts or oceanic plateaus may be accreted or underplated instead of continuing down the slab. A complete or partial ophiolite can be emplaced onto another plate by obduction in suitable convergence histories. Most intact oceanic crust is not saved this way. High-pressure fragments may be entrained in an interface channel or mélange and exhumed; their small preserved volume should not be mistaken for the dominant global mass flux. Magma generated after slab-derived transfer may also pond and crystallize beneath the upper crust by magmatic underplating, which is a different process from mechanical tectonic underplating of solid slices.

Lithospheric mantle: residual rock and a variable water carrier. Most incoming lithospheric mantle is depleted peridotite left after extraction of ridge melts. Its cold, dense, mechanically coherent portion contributes to slab pull and generally sinks with the plate. Hydrated portions contain serpentine and possibly other hydrous minerals. Breakdown of these phases releases water at conditions that depend on the thermal path, feeding further metasomatism of the mantle wedge and sometimes dehydration embrittlement. The latter is a proposed contributor to intermediate-depth earthquakes, not an exclusive explanation for all such events. Very cold paths may transfer some water onward in high-pressure hydrous phases or as hydrogen incorporated in nominally anhydrous minerals.

Do not confuse the incoming hydrated lithospheric mantle with newly serpentinized forearc mantle in the overriding plate. The latter receives slab-derived fluids and can temporarily store their water. Hydrated, relatively buoyant interface material can facilitate return flow and tectonic exhumation, while the colder deeper bulk of the lithospheric mantle continues down. Some peridotite may also be accreted or obducted with an ophiolite. These exchanges mean that even an exposed serpentinite requires structural and chemical context before it can be assigned to its original plate.

Deep recycling and eventual return. The residual eclogite, remaining sediments and lithospheric mantle can enter the deeper mantle. A slab can temporarily stagnate around the mantle transition zone or penetrate into the lower mantle, depending on buoyancy, phase transformations, geometry and mantle viscosity. Crustal material can remain as compositionally distinct domains, mix, or react with surrounding peridotite; it need not retain the near-surface eclogite assemblage indefinitely as pressure rises. Subsequent mantle convection can return recycled components toward spreading regions or mantle plumes, where partial melting incorporates them into new basalt. A primary study of Hawaiian basalt illustrates a specific model in which melts derived from recycled crust react with peridotite to form a pyroxenite source. It is an interpretation of combined chemical evidence, not a unique label attached to every enriched basalt.^[ref]

How the pathways can be observed. Seismic reflection profiles, drilling, wedge geometry and balanced structural sections constrain accretion, fluid escape and tectonic erosion. High-pressure metamorphism, mineral zoning, radiometric dating and pressure-temperature-time paths in exhumed rocks reveal burial, reaction and return. Their reconstructable histories are especially useful when deformation and fluid inclusions are linked to the dated mineral growth. Earthquake distributions, seismic tomography, seismic attenuation and electrical conductivity constrain the geometry and physical state of the slab and mantle wedge, although fluids, melts and temperature can produce nonunique signals.

Arc magmas carry complementary chemical evidence: relatively mobile barium, boron, lead or strontium can trace fluid-mediated transfer, whereas sediment-sensitive thorium and isotope ratios can help identify other contributions. Element mobility changes with fluid composition and pressure-temperature conditions, so no one element is an infallible tracer. Boron isotope ratios, radiogenic strontium isotope ratios and lead isotope ratios should be interpreted with measured incoming sediments and altered oceanic crust. Arc gases and forearc fluid discharge constrain volatile return; ocean-island basalts, mantle xenoliths and diamond inclusions provide possible evidence of deeper recycling. Each observation samples only part of the system.

For any element $X$, a useful control-volume statement isHere permanent accretion is counted outside the chosen reactive control volume, return includes fluid, melt and exhumed-solid exports, and transient underplating or reservoir growth contributes to storage until exported. For a different boundary choice, the terms must be regrouped consistently. The three incoming layers can have very different transfer efficiencies for bulk rock, water, carbon and a particular trace element. A small mass of escaping fluid can dominate an element's return while most of the solid slab continues into the deep mantle.

Test geological associations and their chronology. The most persuasive hypothetical record would combine rigid-block relative motion, creation of oceanic lithosphere, its destruction at a coherent margin, and repeated assembly and dispersal of continents. I would compile independently dated rock and structural occurrences in age bins, map their associations, and distinguish primary formation from later emplacement. The aim is to evaluate alternative tectonic regimes, not simply to collect the oldest example of a familiar name.

Oceanic lithosphere and sutures. An ophiolite association containing residual peridotite, gabbro, sheeted dikes and submarine basalt could demonstrate construction of an oceanic section. Its case for plate tectonics strengthens if it is associated with an oceanward sedimentary succession, a metamorphic sole, an accretionary prism or mélange, and eventual emplacement along a suture zone between formerly distinct blocks. Date construction, metamorphic heating and emplacement separately. A dismembered collection of ultramafic and mafic rocks need not be a complete ophiolite; an isolated volcanic pile or greenstone belt can also arise in a plateau or vertical-overturn setting. Hotter early mantle may produce oceanic sections unlike a modern template.

Cold burial beside a hot arc. Blueschist and eclogite with well-constrained low temperature/pressure ratios would support unusually deep burial before substantial heating. Coesite or metamorphic diamond in a suitable continental crust protolith could establish ultrahigh-pressure metamorphism, consistent with deep continental burial and return. Reconstruct pressure-temperature-time paths using mineral assemblages, zoning, reaction textures and radiometric dating; a peak pressure without its timing and burial geometry gives a weaker constraint. Eclogite alone only indicates appropriate pressure-temperature-composition conditions and may also form at the base of thick crust.

An approximately coeval, spatially organized pair of low thermal-gradient and high thermal-gradient metamorphic belts would be stronger evidence for juxtaposition of a cold descending plate and a hotter volcanic arc or hinterland. Test the original spatial relation rather than pairing unrelated rocks brought together much later. A statistical study of metamorphic temperature/pressure distributions illustrates how gradual widening and bimodality can be used to evaluate changing tectonic behavior. The ratio is an apparent metamorphic thermal gradient, not necessarily a directly measured steady geothermal gradient.^[ref]

The absence of old blueschist is not a decisive absence of old subduction. A hotter thermal regime may suppress its production, and later heating can transform it. The test should therefore include the distribution of pressure-temperature-time paths predicted by early-planet models, rather than demanding the youngest modern mineral assemblages at all ages.

Kinematic structures and basin evolution. Long, coherent thrust belts, imbricated sediments, folds, regionally consistent shear sense, major strike-slip faults, and suture zones can identify lateral shortening and relative displacement. A reconstructed ocean-facing volcanic arc, forearc basin and accretionary prism with a common polarity is more compelling than isolated shortening. Mountain building alone is not exclusive to plate tectonics: vertical instabilities and impacts can also deform rock. The length scale, sequence, strain partitioning and linkage between structures matter.

For repeated opening and closing, seek a dated progression from continental rifting, through a subsiding passive margin and an intervening oceanic assemblage, to convergence, continental collision and renewed rifting. Matching stratigraphy, sedimentary provenance and structural restoration on opposing blocks can test whether a reconstructed Wilson cycle is geometrically possible. Paleomagnetism from independently dated, demonstrably primary magnetizations could show differential latitudinal motion and rotation of separate blocks. Relative motion between blocks is more useful than motion of one block, which could include true polar wander. Remagnetization, inclination shallowing and longitude ambiguity must be assessed.

Secular changes require an archive model. Compile the incidence, spatial scale and recurrence of these associations through time, normalized where possible by exposed rock area, sampling effort and dating opportunities. Include detrital zircon and sedimentary provenance where they preserve information from eroded source rocks, while recognizing zircon fertility and sedimentary sorting biases. Increased abundance of plate-like associations in several independent regions could support their transition from local episodes to a widespread regime. A sharp break is only one possible outcome; a progressive increase in persistence or geographical coverage would support gradual establishment.

A useful conceptual accounting iswith additional redistribution between age bins if ages are reset or misassigned. This is not a calibrated dating law: it shows why an observed first appearance need not equal a true first formation. Subduction consumes oceanic lithosphere; erosion, metamorphism, tectonic reworking and burial selectively remove or obscure evidence. The oldest archive is especially incomplete, and some apparently diagnostic assemblages only become likely as the planet cools. An age peak may measure enhanced preservation during continental collision rather than an increased production rate.

State the chronological inference precisely. If an unambiguous assemblage forms at time $t_e$, then the required process was operating by $t_e$; an onset time measured forward from planetary formation obeys $t_{\mathrm{onset}}\le t_e$. If both are expressed as ages before present, the inequality reverses: the onset age is at least as old as the assemblage age. Constraining how much earlier onset could have occurred requires well-sampled older records and a credible prediction that the sought evidence would have formed and survived. Several coeval, independent records consistent with sustained horizontal recycling give a stronger inference of widespread plate tectonics than the oldest ambiguous occurrence of any single rock type. Combined with geodynamic modelling and geochemistry, the defensible answer would report a range for first local activity and a potentially different range for establishment of a persistent global system.