For a boundary layer with exponentially varying outer velocity, the ansatz has . Matching it to requires and . The nonlinear terms in the stream-function equation scale as , whereas scales as . Matching exponents gives , hence
More explicitly,
Canceling the common factor gives
Together with , the other two conditions are
They represent wall no slip and outer-flow matching, respectively.
Use autonomous third-order reduction using the dependent variable. On a monotone branch where can serve as the independent variable, the chain rule gives
Therefore the reduced second-order equation is
The wall and matching conditions become
For the usual positive outer flow this is the limit . The reduced equation is singular at : if , then and , so has square-root behavior as a function of near the wall. A finite value for should not be imposed as an extra boundary condition.
An attached similarity profile must approach as . Linearizing about gives, for the small velocity correction ,
When , one independent far-field correction decays with a Gaussian factor; when , the two nontrivial asymptotic modes grow, one algebraically and one exponentially, so a nonconstant wall profile cannot decay into the prescribed outer flow. Thus the attached exponential similarity construction requires
Equivalently the outer speed increases along the direction of motion, giving a favorable pressure gradient. In the intended flow away from the leading edge along positive , this means and . The sign-reversed choice describes locally favorable flow in the opposite direction; it is not a layer developing downstream from the stated leading edge.
The asymptotic approximation also requires a geometrically thin layer, away from the leading-edge region. Comparing its thickness with the streamwise variation length gives the local condition . An exponentially decaying outer speed eventually violates this condition on an infinite downstream interval. These scale and orientation requirements distinguish formal similarity reduction from a uniformly valid attached boundary layer.

Articles by others on the same topic (0)

There are currently no matching articles.