RC low-pass frequency response ($H(\omega )=1/(1+\mathrm{i}\omega RC)$)

Use the complex amplitude convention $v(t)=\mathrm{Re}(\hat{V}{e}^{\mathrm{i}\omega t})$, where $\omega =2\pi f$ is the angular frequency and $f$ is the frequency in cycles per second. Substitution into the RC low-pass filter equation replaces the time derivative with multiplication by $\mathrm{i}\omega$, giving its continuous-time frequency responseHere $\varphi$ is the output-minus-input phase difference; a negative value means the output lags. Equivalently, the voltage divider formed from the electrical impedances $R$ and $1/(\mathrm{i}\omega C)$ gives the same ratio. For an input $A\cos (\omega t)$, the sustained output is $A|H|\cos (\omega t+\varphi )$ after the initial exponential decay has died away.

Define the cutoff frequency by a voltage amplitude ratio $1/\sqrt{2}$ relative to the low-frequency value:On a Bode plot, the voltage gain in decibels isAt the cutoff frequency it is $-3.0103\mathrm{dB}$, and far above that frequency it approaches a decrease of $20\mathrm{dB}$ per factor of ten in $f$. There is a smooth transition rather than an abrupt wall. The squared voltage ratio is one half at the corner; converting that statement to a power ratio requires the same real electrical resistance for the compared voltages. It does not mean that an unloaded capacitor dissipates half the source power.

For $R=2.2\mathrm{k}\Omega$ and $C=47\mathrm{nF}$, the cutoff frequency is $f_c\approx 1.5392\mathrm{kHz}$. A $1\mathrm{V}$ peak input at $0.1f_c$, $f_c$, and $10f_c$ produces peak output amplitudes of approximately $0.9950\mathrm{V}$, $0.7071\mathrm{V}$, and $0.09950\mathrm{V}$, with phase differences $-5.711^{\circ }$, $-45^{\circ }$, and $-84.289^{\circ }$. Thus a wanted oscillation at $0.1f_c$ is almost preserved while an unwanted one at $10f_c$ is reduced by about a factor of ten in voltage. The superposition principle lets these two responses be added when both oscillations occur in the same signal.