 Permanganate-iron titration

A proposed modern teaching measurement puts a pipette-measured portion of an iron ${\mathrm{Fe}}^{2+}$ chemical solution in a conical flask, acidifies with excess dilute sulfuric acid, and adds standardized potassium permanganate from a clamped burette while swirling. The documented endpoint principle is that added purple permanganate is consumed until the first small excess leaves a pale purple colour; no separate colour indicator is required. Insufficient acidity can produce brown manganese dioxide, invalidating the assumed five-electron half-reaction.^[ref]

Record initial and final burette readings; their difference is the delivered volume $V$. The following controls are proposed additions to test the inference. Run a reagent blank with the same water, sulfuric acid and endpoint criterion but no sample, obtaining $V_b$. Use a separately established potassium permanganate concentration $c$, clear the burette tip of air, and repeat sample portions. A known added amount of substance of ${\mathrm{Fe}}^{2+}$ should increase consumption by one fifth of that amount. A blank estimates reagent demand and the small endpoint excess; it cannot remove an interfering sample reactant.

Assuming complete, selective reaction according to the acidic permanganate-iron balance, the corrected inference isWith $c$ in $\mathrm{mol}{\mathrm{L}}^{-1}$, use $V$ and $V_b$ in litres. As an original stipulated calculation, not an experimental result, take $c=0.02000\mathrm{mol}{\mathrm{L}}^{-1}$, $V=12.60\mathrm{mL}$ and $V_b=0.10\mathrm{mL}$. Then the permanganate consumption is $0.2500\mathrm{mmol}$ and the inferred ${\mathrm{Fe}}^{2+}$ amount is $1.250\mathrm{mmol}$. In a $25.00\mathrm{mL}$ sample portion this corresponds to $0.05000\mathrm{mol}{\mathrm{L}}^{-1}$.

In this example the corrected volume is $12.50\mathrm{mL}=0.01250\mathrm{L}$. The acidic permanganate-iron balance gives $z_A=1$ for ${\mathrm{Fe}}^{2+}$ and $z_T=5$ for permanganate. Thus $0.2500\mathrm{mmol}$ of permanganate accepts $1.250\mathrm{mmol}$ of formal electrons, exactly what $1.250\mathrm{mmol}$ of ${\mathrm{Fe}}^{2+}$ supplies. The amount of substance ratio is five to one, despite equality of the exchanged electron amounts.

The denominator is the original $25.00\mathrm{mL}$ aliquot, not its final volume after adding sulfuric acid, water and titrant. Such dilution changes concentrations in the flask without changing the initial sampled amount of substance of ${\mathrm{Fe}}^{2+}$. Omitting the $0.10\mathrm{mL}$ titration blank would instead give $1.260\mathrm{mmol}$ and $0.05040\mathrm{mol}{\mathrm{L}}^{-1}$, an overestimate of $0.80\%$ relative to the corrected constructed value. The displayed digits express the stipulated calculation, rather than establish its measurement uncertainty.

The endpoint detects residual permanganate, not the iron identity directly. Other sample reactants that consume permanganate raise the apparent ${\mathrm{Fe}}^{2+}$ amount; prior oxidation of sample ${\mathrm{Fe}}^{2+}$ to ${\mathrm{Fe}}^{3+}$ lowers it. A recovery check probes response to the added iron but does not prove absence of every interference. The readout determines the reacting ${\mathrm{Fe}}^{2+}$ inventory under the stated conditions, rather than total iron in an arbitrary mixture. No measured titres are asserted here.