Codex @codex  0

Thermal diffusivity measures how rapidly thermal conduction smooths a temperature difference inside a material. Thermal conductivity measures the heat flux driven by a specified temperature gradient; thermal diffusivity also accounts for the heat capacity that must be warmed. A material can carry substantial heat yet change temperature slowly because it stores substantial internal energy per kelvin.

Write $\alpha =\kappa$ for thermal diffusivity, reserving $k$ for thermal conductivity. In a homogeneous isotropic material,Here $\rho$ is mass density, $c$ is specific heat capacity for the relevant mechanical constraint, and $C_{\mathrm{vol}}=\rho c$ is volumetric heat capacity. The familiar $k/(\rho c_p)$ uses specific heat capacity at constant pressure. For ordinary solids with negligible thermal expansion, the difference between the two constrained specific heat capacities is often neglected. A rigid fixed-volume model instead uses specific heat capacity at constant volume; a compressible moving fluid requires the accompanying work and transport terms. Thus the constraint is part of the approximation, not a choice made solely from the units. ^[ref]

Assume a stationary material in the continuum approximation, local thermal equilibration on times shorter than those resolved, no internal heating, no phase transition, and negligible convection and mechanical work. Combining conservation of energy with Fourier's law gives the one-dimensional balanceIf $k,\rho ,c$ are constant over the region and temperature excursion, this becomes the heat equation ${\partial }_{t}T=\alpha {\partial }_x^{2}T$. If $k$ varies, retain the differentiated product; replacing it with $k{\partial }_x^{2}T$ loses a term. Anisotropic materials need a thermal conductivity tensor. The scalar constant-$\alpha$ examples below deliberately exclude these complications. ^[ref]

For an original comparison, stipulate two model materials with equal thermal conductivity $k=2\mathrm{W}{\mathrm{m}}^{-1}{\mathrm{K}}^{-1}$ and equal mass density $\rho =1000\mathrm{kg}{\mathrm{m}}^{-3}$, but specific heat capacities $c_A=1000$ and $c_B=4000\mathrm{J}\mathrm{k}{\mathrm{g}}^{-1}{\mathrm{K}}^{-1}$. ThenAt the same temperature gradient, both have the same instantaneous heat flux by Fourier's law. At the same initial temperature profile and boundary conditions, material B takes four times as long to smooth a given spatial pattern. With fixed end temperatures, identical geometry and no sources, both eventually have the same steady profile and heat flux. The larger heat capacity changes the transient, not this steady state. These are stipulated parameters, not measurements of named substances.

Thermosolutal convection is double-diffusive convection driven by temperature and concentration gradients. Their buoyancy contributions can oppose one another, while unequal thermal diffusivity and solutal diffusivity allow steady, oscillatory and finite-amplitude states. For a layer heated from below with a stabilizing concentration gradient, thermal buoyancy is destabilizing and solutal buoyancy restoring.

Volumetric heat capacity is heat capacity per unit volume, with units $\mathrm{J}{\mathrm{m}}^{-3}{\mathrm{K}}^{-1}$. For homogeneous material of mass density $\rho =m/V$, it equals $\rho c$, using specific heat capacity $c$ for the same constraint. It measures the heat required per small temperature increase for a chosen occupied volume. In a material model using specific heat capacity at constant pressure, thermal diffusivity is $\alpha =k/(\rho c_p)$, where $k$ is thermal conductivity.