A random-effects meta-analysis allows differences in true treatment effects across countries and eligibility criteria. For trial , let be its estimated log odds ratio and its estimated within-trial variance. A usual approximate statistical model is
independently across trials, with independent of sampling errors. Here is the mean true log odds ratio in the population of comparable trials, and is between-trial heterogeneity, not additional sampling error. Therefore , and for a fitted heterogeneity value,
One can estimate by restricted maximum likelihood or another justified method; is a plug-in conditional variance and does not fully account for estimating heterogeneity. With only six studies that uncertainty matters. Different eligibility rules motivate this random effect but do not by themselves establish exchangeability or remove bias; known effect modifiers may warrant stratification or regression.
Use leave-one-study-out influence analysis: fit all six trials, then omit Cohen 1989 and refit both and . Report , the corresponding change in the odds ratio, and changes in the confidence interval and heterogeneity. As a diagnostic with heterogeneity held fixed, writing gives
The fitted Cohen weight would be and . A precise but discordant trial can have large influence; refitting assesses additional influence through heterogeneity. The other five trials' data are absent, so a numerical six-trial influence assessment is not identifiable from the displayed table.
A network meta-analysis can offer three distinct benefits, assuming a connected treatment network and credible transitivity in network meta-analysis.
These are potential benefits, not guarantees: heterogeneous effect modifiers, inconsistent evidence, disconnected networks or imprecise rankings can defeat them.
Under the null hypothesis of consistency, has approximately zero expectation and variance , since the displayed trials are independent. Thus a two-sided Wald test uses
The observed difference is , and . Its two-sided p-value is approximately , so there is no detectable discrepancy here. Failure to reject is not proof of consistency: this test has limited statistical power, and transitivity in network meta-analysis also needs substantive assessment. If evidence sources overlap, replace by .
Let and be independent, approximately unbiased estimates of one consistent treatment effect, with variances . The inverse-variance weighted mean gives
Indeed, weights give variance ; differentiating gives , the weight on the direct estimate. Here the three displayed trials give , , and hence with variance . This numerical pooling uses the displayed evidence, not the unavailable data from all twelve trials. A shared study or shared control would introduce covariance, requiring the corresponding correlated-estimator formula; inconsistency would invalidate the common-effect interpretation.
Write and for the estimated log odds ratios relative to the common control. Indirect treatment comparison uses the consistency relation . For independent trials, subtraction adds their variances, giving
The substantive assumption is transitivity in network meta-analysis: the study populations, outcome definitions and follow-up are sufficiently comparable, particularly in their distributions of effect modifiers, that the two control comparisons estimate effects applicable to the same target population. The common control's name alone does not justify that assumption. This also assumes comparable marginal odds ratios; these need not equal covariate-adjusted odds ratios even without confounding.
Using the supplied rounded variances and the given standard normal quantile, the approximate confidence interval is
On the odds ratio scale this is , with approximate limits . The estimated odds of recurrent stroke under treatment are about 28% of those under , a reduction of about 72% in odds. The interval excludes equal odds, so this comparison provides evidence of lower odds under if the indirect treatment comparison assumptions hold. These are odds, not a 72% reduction in probability; a confidence interval describes the long-run coverage of the procedure, not a posterior probability for this particular interval.
Let have rows and let be the spatial covariance matrix with . Conditional on chosen covariance parameters, the best linear unbiased estimator of the drift coefficients is the generalized least squares estimator
The printed procedure first estimates the linear drift from depth ~ y, constructs a binned residual empirical semivariogram, fits a Gaussian semivariogram to it, and then uses the fitted covariance in generalized least squares trend estimation and universal kriging. The missing fit could be supplied as
gauss.model2 <- fit.variogram(smvg2, vgm(0.5, "Gau", 1, 0))
where those arguments are initial values, not the reported final estimates. Such semivariogram fitting typically minimizes a weighted sum of squared discrepancies between binned empirical values and model values; it is not automatically a joint Gaussian likelihood maximization. One can iterate: form residuals using the current drift, refit the covariance model, recompute the generalized least squares drift, and repeat until changes are small. The displayed commands themselves show a single sequence, not evidence that such iteration occurred.
A likelihood-based alternative estimates the two blocks coherently from
Substitute to obtain a profile log-likelihood, maximize over and with a positive-definite matrix , and recover the drift coefficients from the optimizing covariance. Restricted maximum likelihood adds the design determinant term and uses in place of in the normalizing term, up to a fixed-design constant. It can reduce bias from estimating the drift before the covariance. A zero fitted nugget is a legitimate boundary estimate, not proof that measurement error is absent. Estimate drift using covariance-weighted regression, and spatial dependence from drift-adjusted variation, with the two stages or likelihood explicitly distinguished.
The universal kriging model has a linear drift in and a zero-mean Gaussian residual field:
The Gau range parameter in this software is , since its semivariogram uses . The output gives , , and , hence . The exact Gaussian range is infinite; the 95-percent practical range is approximately in the coordinate distance units.
The BLUE=TRUE option asks for the best linear unbiased estimator of the drift, rather than the full field kriging prediction. Thus the two printed fitted trends give at and at . Therefore
There is no coefficient in the drift. The reported variances and are the variances of the corresponding estimated trend values, not full-field prediction variances. They do not determine the slope variance without its covariance with the intercept. The interpolated map can still vary with through the correlated residual prediction, even though the fitted deterministic drift depends only on .
The first binned empirical semivariogram rises strongly through the displayed distances, approximately quadratically, with no visible sill. The spatial data plot shows higher depth at larger . A stationary residual covariance should not be asked to explain that deterministic drift.
For a model with stationary zero-mean residual field, each raw squared difference has expectation
With linear drift , the added term is . Its average within distance bins can grow with separation, producing the shape seen in the first plot. The empirical semivariogram uses half the average squared difference over the pairs in each bin, so removing only a common intercept does not remove this drift contribution.
The formula depth ~ y estimates and removes a linear drift before computing a residual empirical semivariogram. The second graph levels off near with a fitted zero nugget and a finite scale, making the Gaussian residual covariance a plausible working model. Estimate the drift and fit spatial dependence to residuals rather than the raw depth differences. Estimated residuals are not the true errors, so their semivariogram has estimation effects; sparse long-distance bins are also noisy. These graphs support the model but do not establish stationarity or isotropy.
The subpart refers to svgm and svgm2, while the code calls the objects smvg and smvg2. Also the printed code omits the line that fits gauss.model2 before plotting or using it. The supplied output must be interpreted as the result of that missing residual-variogram fit, rather than as an executable complete script.

Pinned article: Introduction to the OurBigBook Project

Welcome to the OurBigBook Project! Our goal is to create the perfect publishing platform for STEM subjects, and get university-level students to write the best free STEM tutorials ever.
Everyone is welcome to create an account and play with the site: ourbigbook.com/go/register. We belive that students themselves can write amazing tutorials, but teachers are welcome too. You can write about anything you want, it doesn't have to be STEM or even educational. Silly test content is very welcome and you won't be penalized in any way. Just keep it legal!
We have two killer features:
  1. topics: topics group articles by different users with the same title, e.g. here is the topic for the "Fundamental Theorem of Calculus" ourbigbook.com/go/topic/fundamental-theorem-of-calculus
    Articles of different users are sorted by upvote within each article page. This feature is a bit like:
    • a Wikipedia where each user can have their own version of each article
    • a Q&A website like Stack Overflow, where multiple people can give their views on a given topic, and the best ones are sorted by upvote. Except you don't need to wait for someone to ask first, and any topic goes, no matter how narrow or broad
    This feature makes it possible for readers to find better explanations of any topic created by other writers. And it allows writers to create an explanation in a place that readers might actually find it.
    Figure 1.
    Screenshot of the "Derivative" topic page
    . View it live at: ourbigbook.com/go/topic/derivative
  2. local editing: you can store all your personal knowledge base content locally in a plaintext markup format that can be edited locally and published either:
    This way you can be sure that even if OurBigBook.com were to go down one day (which we have no plans to do as it is quite cheap to host!), your content will still be perfectly readable as a static site.
    Figure 5. . You can also edit articles on the Web editor without installing anything locally.
    Video 3.
    Edit locally and publish demo
    . Source. This shows editing OurBigBook Markup and publishing it using the Visual Studio Code extension.
  3. https://raw.githubusercontent.com/ourbigbook/ourbigbook-media/master/feature/x/hilbert-space-arrow.png
  4. Infinitely deep tables of contents:
    Figure 6.
    Dynamic article tree with infinitely deep table of contents
    .
    Descendant pages can also show up as toplevel e.g.: ourbigbook.com/cirosantilli/chordate-subclade
All our software is open source and hosted at: github.com/ourbigbook/ourbigbook
Further documentation can be found at: docs.ourbigbook.com
Feel free to reach our to us for any help or suggestions: docs.ourbigbook.com/#contact