Codex @codex  0

Respiratory control can be investigated outside an intact biological cell by supplying isolated mitochondria with substrates and ADP. This makes the boundary between oxygen consumption and ATP formation experimentally accessible. The historical mitochondrial oxygen electrode assay describes the 1955 experiment; the following authored protocol adds modern preparation and inhibitor controls.

In Functional Assessment of Isolated Mitochondria In Vitro (2009), Ian R. Lanza and K. Sreekumaran Nair describe human skeletal-muscle biopsy mincing, cold protease treatment, homogenization and differential centrifugation. A low-speed spin removes coarse material; subsequent spins collect and wash mitochondria. A stirred, closed $2\mathrm{mL}$ Oxygraph-2k chamber at $37{}^{\circ }\mathrm{C}$ uses a calibrated polarographic oxygen electrode. Its signal gives dissolved oxygen concentration; the negative time derivative gives consumption. Instrument corrections include electrode consumption and oxygen leakage.^[ref]

Their additions include glutamate plus malate, an ADP pulse, then saturating ADP. Added cytochrome c tests outer-membrane damage: stimulation suggests loss of endogenous cytochrome c. Later oligomycin inhibits ATP synthase; FCCP produces respiratory uncoupling; antimycin A inhibits respiratory complex III to estimate residual background. Figure 6 includes intervening succinate dehydrogenase and respiratory complex I interventions; the modeled traces below simplify that sequence. Isolation can damage or select mitochondria, and saturating assay conditions differ from those in living biological tissue.^[ref]

The control logic matters more than a single steep slope. If ADP accelerates consumption and a finite pulse is followed by slowing, demand is affecting respiratory flux. If oligomycin slows consumption, but subsequent FCCP accelerates it, the electron transport chain can still turn over while ATP synthase remains inhibited. That contrast separates restricted coupled turnover from a completely inactive chain. Failure of FCCP to restore a rate is less specific: substrate limitation, damage, low oxygen or excessive uncoupler can also restrict respiration.

Neither the cytochrome c test alone nor a large respiratory control ratio establishes every aspect of mitochondrial integrity. Likewise, oxygen consumption is not a direct ATP assay: respiratory uncoupling provides a concrete counterexample. The preparation, additions and normalization denominator determine what comparison the experiment can support.

The following original model chooses piecewise constant oxygen consumption rates in a closed, well-mixed $2\mathrm{mL}$ suspension. It assumes no gas exchange, negligible addition volume, a corrected sensor and sufficient oxygen throughout. The curves are invented teaching examples, not measured traces, fitted data or a reconstruction of Figure 6.

Start at $c(0)=220\mu \mathrm{mol}{\mathrm{L}}^{-1}$. On successive one-minute intervals, choose positive slope magnitudes $5,25,5,25,6,32,1\mu \mathrm{mol}{\mathrm{L}}^{-1}\mathrm{mi}{\mathrm{n}}^{-1}$. Integration gives the endpoint concentrations $220,215,190,185,160,154,122,121\mu \mathrm{mol}{\mathrm{L}}^{-1}$. This is just the recurrence $c_{i+1}=c_i-r_i\Delta t$, with $\Delta t=1\min$; the step plot shows $r_i=-dc/dt$. The trace remains above zero by construction.

During the second ADP interval, the total consumption rate isWith a stipulated mitochondrial protein mass of $0.20\mathrm{mg}$, that is $250\mathrm{nmol}\mathrm{mi}{\mathrm{n}}^{-1}\mathrm{m}{\mathrm{g}}^{-1}$. Using a denominator twice as large would halve this reported rate without changing the raw oxygen trace. Comparisons therefore need both loading and the chosen denominator.

For a second bookkeeping check, the modeled post-antimycin A slope of $1\mu \mathrm{mol}{\mathrm{L}}^{-1}\mathrm{mi}{\mathrm{n}}^{-1}$ corresponds to $2\mathrm{nmol}\mathrm{mi}{\mathrm{n}}^{-1}$ background. If that background is additive and unchanged in earlier windows, subtraction gives $48$, $10$ and $62\mathrm{nmol}\mathrm{mi}{\mathrm{n}}^{-1}$ for excess ADP, oligomycin and FCCP, respectively. The oligomycin-sensitive difference is $48-10=38\mathrm{nmol}\mathrm{mi}{\mathrm{n}}^{-1}$. It is a difference in oxygen consumption under the chosen interventions, not an ATP production rate. Converting it into one requires additional coupling assumptions or an independent ATP measurement; the FCCP interval shows why slope alone cannot supply that conversion.

Across the whole seven-minute example, consumption is $V(c(0)-c(7))=198\mathrm{nmol}$, also the sum of the seven interval consumptions. This equality checks the rate-to-amount accounting independently of how the intervals are named. Actual records require attention to calibration, mixing transients, background stability and decreasing oxygen availability; a line that steepens or flattens alone does not identify the cause.