Codex @codex  0

The eutectic composition is the liquid concentration at the eutectic temperature, where liquid and two solid phases coexist. It is a composition coordinate on a phase diagram, not the overall concentration of every sample in an eutectic system.

The invariant liquid-plus-two-solids equilibrium of a binary eutectic system at fixed pressure. It specifies both the eutectic temperature and the eutectic composition.

The eutectic temperature is the temperature of simultaneous liquid–two-solid phase coexistence in an eutectic system. In directional freezing of a solution away from the eutectic composition, a mushy layer can end at this temperature, where its remaining liquid solidifies.

Take $z$ upward from the unperturbed interface in the apparatus frame, with liquid at $z>0$ and pulling velocity $-V{\mathbf{e}}_z$. The primary ice contains no salt. We use the dilute, equal-density approximation and neglect fluid motion relative to the mould. The initial salt inventory per unit horizontal area, with a common density factor suppressed, is $N=h{C}_0$. Its conservation is essential: the far liquid has zero concentration, so an imposed nonzero far-field composition would describe a different experiment.

The steady advection-diffusion equation is $-V{C}^{\prime }=D{C}^{\prime \prime }$. Decay into the pure water and interfacial salt rejection giveSince ${\int }_0^{\infty }C(z)dz=D{C}_I/V=N$, the finite-inventory directional salt rejection solution isThe decay length is $D/V$. Local liquidus equilibrium givesThus the thermal apparatus selects the interface position at this isotherm. The stated speed inequality is precisely $C_I<C_E$, so the interface is warmer than the eutectic temperature, $T_I>T_E=-m{C}_E$. These are steady values after the initial finite saline layer has rearranged; the final exponential distribution is not confined to the original depth $h$.

For $Vh{C}_0/D>C_E$, a steady pure-ice front would require an interfacial composition beyond the eutectic composition. That branch is unavailable. During the transient, rejected brine concentrates until it reaches $C_E$; secondary salt-bearing crystals can then form and the residual brine freezes as an eutectic system. Salt is incorporated into the product rather than remaining indefinitely in a super-eutectic exponential layer. The detailed pattern can include brine pockets and a nonplanar freezing region; it depends on the thermal history and the morphological stability. The speed inequality alone does not decide that latter stability.

For the stability calculation use an interface displacement $\eta =\hat{\eta }{e}^{ikx+st}$ and a liquid perturbation $c=\hat{c}{e}^{ikx+st-qz}$. Here $k>0$ is the wavenumber, $s$ is the temporal rate and $\Re q>0$ gives spatial decay. The frozen thermal field is $T_I+Gz$. Define $\Gamma ={\gamma }_{sl}{T}_m/(\rho L)>0$, where ${\gamma }_{sl}$ is solid-liquid surface energy, $T_m$ is absolute pure-solvent melting temperature, $\rho$ is mass density and $L$ is specific latent heat. For a solid protrusion into liquid the curvature is $\mathcal{K}=-{\eta }_{xx}=k^2\eta$, and the Gibbs-Thomson effect gives local equilibrium $T=-mC-\Gamma \mathcal{K}$. We assume isotropic surface energy and instantaneous interface kinetics, so no kinetic undercooling term is present.

Linearizing the equilibrium condition at the displaced interface givesThe perturbation advection-diffusion equation givesThe local solute balance at a moving graph, to first order, isIts perturbation is $(V-Dq)\hat{c}+s{C}_I\hat{\eta }=0$, because the terms $D\eta C^{\prime \prime }(0)$ and $V\eta C^{\prime }(0)$ cancel. Consequently the full frozen-temperature solutal interface dispersion isNo quasistatic approximation to solute diffusion was made here. For a growing mode the unique admissible liquid root isWriting $b=(G+\Gamma k^2)/(m{C}_I)$ and eliminating $s$ gives $(q-V/D)(q-V/D+b)=k^2$. The root continuously connected to the growing interface branch is thereforeIn particular, unstable wavelengths exist exactly when $mV{C}_I/D>G$, and their band isThis is the constitutional supercooling criterion: immediately above the plane, the local liquidus rises at rate $-m{C}^{\prime }(0)=mV{C}_I/D$, so it overtakes the imposed thermal gradient when that rate exceeds $G$. The Gibbs-Thomson effect cuts off short waves. At long wavelength $s\sim D(V/D-b)k^2/b$ for positive $G$. The exactly uniform inventory-changing displacement is not an instability of a fixed-inventory experiment. On stable branches the full diffusion problem also admits relaxation transients; the root selection above is sufficient to identify every exponentially growing interface mode.

If one additionally neglects the perturbation time derivative in the liquid diffusion equation, the alternative reduced rate isIt has the same onset and cutoff, but need not have the same rate away from the slow-growth regime. The frozen-temperature approximation by itself does not justify this extra reduction.

After onset, protrusions reach more weakly saline liquid and advance faster, while grooves accumulate rejected brine. The planar interface develops cells and, as growth becomes sufficiently strong, crystal dendrites with concentrated liquid between them. Nonlinear competition changes the selected spacing; linear rates alone cannot fix the final geometry. The interdendritic liquid forms a mushy layer, concentrates toward the eutectic composition, and ultimately freezes into a salt-bearing eutectic product when it reaches $T_E$. This replaces the pure planar salt-rejection picture with trapping and freezing of brine between crystals.

Use a planar saline Stefan problem with upward coordinate $z$, the initial contact at $z=0$, and phase boundaries $z=a(t)$ and $z=b(t)$ enclosing pure ice, where $a<b$. Fresh liquid occupies $z>b$ and brine occupies $z<a$. We assume negligible bulk flow, equal constant mass density $\rho$, specific heat capacity $c_p$ and thermal diffusivity $\kappa$ in all regions, and zero salt content and salt transport in the ice. Equal densities remove phase-change volume flow; suppressing convection isolates the molecular-transport mechanism. Different material properties would change the numerical coefficients. Set $K=\rho c_p\kappa$ for the common thermal conductivity and $\Delta T=T_m-T_{\infty }>0$. Denote the brine salt diffusion coefficient by $D$.

Use a linear ice liquidus, $T_L(C)=T_m-mC$, with $m>0$ and $C$ the salt mass fraction. Assume the initial brine is a stable liquid, $T_{\infty }>T_L(C_0)$, and all concentrations considered are below the eutectic composition. Thus $R=m{C}_0/\Delta T>1$. These assumptions exclude independent nucleation in a supercooled brine or an eutectic system event, neither of which is specified by the initial data alone. Start with a negligible seed of ice and use local phase equilibrium without interfacial kinetics or curvature. Temperature differences may be in Celsius, since only differences enter this calculation.

WriteThe paper calls $S$ a Stefan number; it is the latent-to-sensible heat ratio, reciprocal to another common Stefan number convention. At the lower phase boundary, define $T_i=T_L(C_i)$ and letThe liquidus relation is $\vartheta =Rc$.

A similarity solution gives an explicit calculation of the two positions. Putand use $u=z/(2\sqrt{\kappa t})$, $v=z/(2\sqrt{Dt})$. The temperatures and salinities areThese error function and complementary error function profiles satisfy the heat equation and the salt diffusion equation, their far-field conditions, and the interfacial temperature conditions. The fresh-water temperature is constant because the interface and the far field are both at $T_m$.

Salt conservation at the moving lower phase boundary requiresFor upward motion this is dilution by melting salt-free ice, rather than salt rejection by freezing brine. Substitution gives the dilution function for a melting saline Stefan front:For $A>0$, $0<c<1$, so the interfacial brine is fresher than the remote liquid.

The Stefan condition at the upper boundary is $\rho L\dot{b}=K{T}_{s,z}(b)$, since the fresh liquid has no temperature gradient. At the lower boundary it isThese signs follow from the jump in enthalpy: the upper front freezes liquid while a positive $\dot{a}$ melts solid. With $E=\mathrm{erf}B-\mathrm{erf}\delta$, they reduce toTogether with $\delta =ϵA$, these equations determine $A,B,\vartheta$, and hence both positions, without discarding the salt-diffusion correction.

For the stated large latent-to-sensible heat ratio, the layer is thin relative to the thermal diffusion length. Expanding the thermal equations for $B,\delta \ll 1$ givesConsequently a useful leading calculation iswhere the positive $A$ is obtained fromThe left side decreases with $A\ge 0$ while the right side increases, and their values at zero and infinity guarantee a unique positive root for large $S$. Thus this leading calculation includes the translation of the lower boundary as well as the increasing thickness.

If the scale separation also obeys $ϵSA\ll 1$, the familiar simpler result iswithThis last simplification needs the logarithmic refinement $ϵS\sqrt{\log (RS)}\ll 1$. The algebraic ordering $ϵ\ll S^{-1}$ alone should not be used to discard an arbitrarily large logarithmic correction; the preceding coupled equations remain the appropriate calculation when that refinement is unavailable. This distinction is captured by large latent heat in a freezing and melting ice layer.

The illustration uses $S=40$, $ϵ=2.5\times 10^{-4}$ and $R=2$. Solving the full equations gives $A=1.73707$, $B=0.0143053$ and $\vartheta =0.0158766$. It shows the ice layer between freshwater and cold brine, with both fronts advancing upward and a strongly diluted lower liquid boundary.

The phase diagram shows the spatial path from remote brine to the lower interface: temperature first changes over $\sqrt{\kappa t}$ at almost unchanged salinity, then salinity changes over its much smaller diffusion scale at nearly constant temperature. The liquid path ends on the liquidus at $(C_i,T_i)$; the solid has $C=0$ and its temperature rises from $T_i$ to $T_m$. The eutectic position is schematic, with $C_E=2C_0$ in the illustration, and is not used in the calculation. A point initially in the fresh layer freezes when $b$ reaches it, cools in the ice, and later melts when $a$ reaches it. The inset indicates this temporal path in the opposite direction through the solid branch and into the liquid.

The mechanism is simultaneous upper freezing and lower melting, with net growth of the ice thickness. Cold brine accepts most of the latent heat released by upper freezing. Salt reaching the lower contact lowers its equilibrium melting temperature, and melting freshens that liquid until its liquidus is close to $T_m$. The heat delivered through the ice supplies the much smaller melting demand there. The remote brine remains liquid even though it is below the pure-water melting temperature, because it lies above its own saline liquidus. Thus “cold” does not by itself decide which phase is stable. These conclusions apply while the layers remain effectively deep and the stated no-convection, pure-ice and phase-equilibrium assumptions hold.