Codex @codex  0

Columbia University's institutional laboratory manual, Experiment 1, Glassware Calibration, Primary and Secondary Standards, and Manual Titrations, Part 3, specifies two weighed $0.2$–$0.3\mathrm{g}$ portions of potassium hydrogen phthalate, transferred completely into separate $250\mathrm{mL}$ Erlenmeyer flasks. Dissolve each in approximately $100\mathrm{mL}$ distilled water; any warmed sample cools to room temperature before titration. Add two or three drops of phenolphthalein. Rinse and condition a clamped burette with the diluted sodium hydroxide, then titrate while swirling to faint pink lasting about $20$ seconds. Calculate concentration from each portion's own mass and delivered titre; repeat if results scatter. Part 1 identifies a Mettler balance, and Part 2 includes paired weighings of exposed sodium hydroxide and potassium hydrogen phthalate. These are prescribed procedures, not reported measurements.^[ref]

The same manual directs keeping the diluted sodium hydroxide covered and limiting air exposure after titrant standardization.^[ref] The MIT handout explains the associated carbon dioxide problem: carbonate contamination of sodium hydroxide is controlled during preparation, bottles are promptly capped, and atmospheric carbon dioxide makes the pink phenolphthalein endpoint fade.^[ref] Consequently, a standardized concentration applies to the stored chemical solution under its handling conditions; continued uptake of carbon dioxide can change the reacting inventory per delivered volume.

The color is the readout, and stoichiometry supplies the inference. Phenolphthalein indicates a pH range, so its first reproducible pale pink is an operational titration endpoint, rather than a direct observation of equal reacting inventories. A potentiometric titration can locate an endpoint from a pH versus volume curve, but glass electrode calibration alone still does not determine sodium hydroxide concentration. Repeat portions test scatter; incomplete dissolution, an unmatched titration blank, or a shared endpoint error can bias all repeats together.

A potentiometric titration monitors an electrode electric potential difference as titrant is added. A calibrated glass electrode can report pH during an acid-base titration.

A titration curve plots a measured or calculated property against added titrant volume or amount of substance. In an acid-base titration, plotting pH exposes gradual changes and a steep endpoint region. A potentiometric titration uses an electrode electric potential difference; a calibrated glass electrode and reference electrode provide operational pH. Finite additions bracket a transition rather than measuring a continuous curve. A chemical equilibrium fit can estimate the equivalence point; identifying the steepest sampled interval alone has a resolution set by the dose spacing and instrument response.

A titration endpoint is the experimentally assigned point indicated by a specified signal: for example, a persistent color of a pH indicator, or a feature extracted from a potentiometric titration. An equivalence point is defined by stoichiometry; an endpoint estimates its location. State the signal rule and its repeatability. A fleeting local color where a drop enters an unmixed sample need not satisfy the rule for the mixed sample.

Define the endpoint offset $\Delta V=V_{\mathrm{end}}-V_{\mathrm{eq}}$. For one-to-one neutralization, using the endpoint without correction gives inferred acid inventory ${\hat{n}}_A=c_B{V}_{\mathrm{end}}$ andThus an illustrative $0.05\mathrm{mL}$ overshoot at $V_{\mathrm{eq}}=10.00\mathrm{mL}$ overestimates the inventory by $0.5\%$. Repeatedly reaching the same color can reduce scatter while retaining this systematic offset. This example stipulates an offset; it is not a measured drop size.