At the displaced free surface, constant atmospheric pressure and the hydrostatic approximation give the dynamic condition
The linearized kinematic condition is . Combining these relations with
gives
Now let the basic buoyancy be
Thermal-wind balance requires the basic along-front velocity to have vertical shear , so
The basic absolute vorticity and buoyancy gradient are
and hence
For the prescribed disturbance the buoyancy perturbation vanishes, so the linearized buoyancy equation and incompressibility give
The wavevector must therefore satisfy
the disturbance velocity lies along a basic isopycnal. The along-front momentum equation becomes
Projecting the remaining momentum equations onto the divergence-free direction eliminates the pressure and yields
Thus this isopycnal disturbance grows if and only if . Geometrically, is the component of the absolute vorticity along the buoyancy gradient, multiplied by ; the horizontal buoyancy gradient reduces that component through the term . When , the result reduces to the most unstable, nearly horizontal-wavevector limit of part i.
The basic state has velocity field
and buoyancy . For disturbances independent of , the linearized equations are
Substituting a plane wave proportional to and eliminating , , and gives the dispersion relation
Thus the requested coefficients are
An instability exists precisely when some wavenumber pair makes . Since the Brunt–Väisälä frequency satisfies , this is possible exactly when
The basic relative vorticity is , so its absolute vorticity is . Its Ertel potential vorticity is therefore
The instability criterion can consequently be written as : the vertical absolute vorticity has the opposite sign to the planetary vorticity. This is inertial instability, approached most directly by disturbances with .
Measure upward from the heat exchanger and let the steady ice front be at . In the exchanger frame, salt in the liquid satisfies the advection-diffusion equation
The decaying solution and the prescribed total salt mass are
so
The linear liquidus condition fixes the interface temperature as
A solid layer between the exchanger and the interface can therefore exist only if
Write . Heat advection, conduction, and environmental loss give
Its characteristic exponents are
Below the exchanger and above the ice front, boundedness gives
In , the ice temperature is
where
Substitution of these fields into the Stefan condition
gives one scalar equation for the steady height , which can be solved numerically. The heat flux may jump at because the exchanger supplies the required localized cooling.
The local equilibrium freezing temperature ahead of the front is
Because , constitutional supercooling begins when the actual liquid-temperature gradient at the interface is smaller than the liquidus gradient:
Using the solutions above, this is
At criticality the inequality is an equality. If , then and, for ,
The critical curve is proportional to . If , put to obtain
This curve behaves as for small and approaches for large . Supercooling occurs above the corresponding critical curve, where solute rejection steepens the liquidus faster than heat transport raises the actual temperature.
Let
The Neumann solution of the Stefan problem in the ice and substrate is
and
Continuity of heat flux at the contact gives, with ,
and therefore
At the ice–water interface, the water is isothermal at . The Stefan condition gives
Eliminating yields the implicit equation
which determines and hence .
If , then , , and
The highly conducting substrate acts as a reservoir fixed near its initial cold temperature, giving the usual one-phase Stefan problem.
If , then , , and . Consequently
Here heat removal through the poorly conducting substrate is rate limiting, and only a small temperature drop is needed across the much more conducting ice.
When , trajectories conserve
so they are closed ellipses around the origin. Ordinary energy measures circular radius rather than this conserved elliptical radius. Starting on the short-energy axis and rotating to the long-energy axis produces the transient amplification from part d; the state later returns, so the growth is transient despite neutral eigenvalues.
The maximum of is the square of the largest singular value of , hence the largest eigenvalue of . Its determinant is one and its trace gives
For , this is largest when , namely modulo . Then
At such a time is off diagonal, and the maximizing initial condition is with . For negative , the axes interchange and the formula uses .
For , . The matrix exponential therefore gives
Direct multiplication shows for , so is a non-normal matrix. Meanwhile
The symmetric part has eigenvalues , so instantaneous growth is possible exactly when . Under the intended regime this is .
The eigenvalues of are
Since , the origin is linearly stable exactly when the determinant is positive:
or .
Let . The amplitude equation is . For , is the sole equilibrium and every solution tends monotonically to it. At , the origin remains attracting but only algebraically. For , the origin is unstable and the two equilibria
are stable: positive initial data tend to , negative initial data tend to , and remains zero. A plot of therefore shows a pitchfork bifurcation normal form at .
Put and . Differentiating gives the exact stationarity equation
When , the optimum has , so . Therefore
At stationary onset, . The lowest stress-free vertical mode is , for which and . Substitution gives
The rotation term is positive, so rotation raises the critical Rayleigh number and is stabilizing.
For a normal mode proportional to , put . The three scalar equations become
and
Multiplying through by the two scalar operators and eliminating yields
Apply to the linear momentum equation. The pressure and buoyancy terms vanish, while incompressibility gives . Hence
Applying and using the identity supplied in the question gives

Pinned article: Introduction to the OurBigBook Project

Welcome to the OurBigBook Project! Our goal is to create the perfect publishing platform for STEM subjects, and get university-level students to write the best free STEM tutorials ever.
Everyone is welcome to create an account and play with the site: ourbigbook.com/go/register. We belive that students themselves can write amazing tutorials, but teachers are welcome too. You can write about anything you want, it doesn't have to be STEM or even educational. Silly test content is very welcome and you won't be penalized in any way. Just keep it legal!
We have two killer features:
  1. topics: topics group articles by different users with the same title, e.g. here is the topic for the "Fundamental Theorem of Calculus" ourbigbook.com/go/topic/fundamental-theorem-of-calculus
    Articles of different users are sorted by upvote within each article page. This feature is a bit like:
    • a Wikipedia where each user can have their own version of each article
    • a Q&A website like Stack Overflow, where multiple people can give their views on a given topic, and the best ones are sorted by upvote. Except you don't need to wait for someone to ask first, and any topic goes, no matter how narrow or broad
    This feature makes it possible for readers to find better explanations of any topic created by other writers. And it allows writers to create an explanation in a place that readers might actually find it.
    Figure 1.
    Screenshot of the "Derivative" topic page
    . View it live at: ourbigbook.com/go/topic/derivative
  2. local editing: you can store all your personal knowledge base content locally in a plaintext markup format that can be edited locally and published either:
    This way you can be sure that even if OurBigBook.com were to go down one day (which we have no plans to do as it is quite cheap to host!), your content will still be perfectly readable as a static site.
    Figure 5. . You can also edit articles on the Web editor without installing anything locally.
    Video 3.
    Edit locally and publish demo
    . Source. This shows editing OurBigBook Markup and publishing it using the Visual Studio Code extension.
  3. https://raw.githubusercontent.com/ourbigbook/ourbigbook-media/master/feature/x/hilbert-space-arrow.png
  4. Infinitely deep tables of contents:
    Figure 6.
    Dynamic article tree with infinitely deep table of contents
    .
    Descendant pages can also show up as toplevel e.g.: ourbigbook.com/cirosantilli/chordate-subclade
All our software is open source and hosted at: github.com/ourbigbook/ourbigbook
Further documentation can be found at: docs.ourbigbook.com
Feel free to reach our to us for any help or suggestions: docs.ourbigbook.com/#contact