Isothermal gas syringe experiment

A gas syringe makes the distinction between a constant-temperature path and equal-temperature endpoints observable. The Ideal Gas Law Apparatus (TD-8596A), Instruction Manual 012-08420B by PASCO scientific specifies a TD-8596A gas syringe with a mechanical stop, an internal thermistor, an attached pressure sensor and data acquisition. Record the stop volume with the coupling disconnected, then set $40\mathrm{mL}$ and seal the coupling. Record pressure and temperature, compress quickly to the stop near $20\mathrm{mL}$, and hold until both readouts settle. The manual gives roughly $30\mathrm{s}$ for settling and about $0.5\mathrm{s}$ for the thermistor response. Releasing the plunger gives a second transient and a final volume to record.^[ref]

The manual describes a pressure overshoot and temperature rise during rapid compression, followed by cooling at the held volume; the settled pressure remains higher than initially. This illustrates approximately adiabatic compression followed by heat rejection, rather than an isothermal compression throughout. Use the settled initial and compressed readings to test Boyle's law, correcting both syringe readings by the unmarked tubing volume $V_d$:Use absolute pressure, not gauge pressure. A transient comparison of $pV/T$ must pair simultaneous pressure and temperature readings: the sensor lag can separate their peaks.^[ref]

For an additional test of the path, repeat with small compression steps, wait for stable temperature and pressure at every step, and repeat in reverse. Keep the sealed amount of substance, connecting tubing and ambient temperature fixed; prevent hand warming of the barrel and check for leaks by watching for continued pressure drift at held volume after thermal equilibrium. These are proposed controls, rather than reported measurements. Agreement of equilibrated points with Boyle's law supports the fixed-temperature ideal gas law approximation, but does not prove that the rapid segments between them were isothermal processes. A single local temperature sensor can miss temperature gradients; plunger friction can produce direction-dependent readings. The pressure and volume data estimate reversible work only insofar as the path approaches a reversible thermodynamic process; they do not directly measure heat. After motion stops, cooling at fixed volume has zero boundary work and $Q=\Delta U<0$, even though the complete equal-endpoint-temperature ideal gas run has $\Delta U=0$.

A gas syringe traps a gas in a graduated barrel with a movable plunger, allowing its volume to be varied and read. In an isothermal gas syringe experiment, the relevant total volume also includes any connected tubing and sensor cavity containing the same gas.