Airflow Created 2026-10-31 Updated 2026-11-05
Airflow is motion of air, described in the continuum approximation by fields of velocity, pressure, mass density and temperature. A fan can sustain a pressure difference, buoyancy can drive a warm plume, and external motion can carry air past a body. The driving mechanism and boundary geometry determine the resulting flow.
For a characteristic speed much smaller than the speed of sound, an incompressible flow model can often describe mechanical motion when thermal density changes are also small. The Mach number tests the acoustic comparison, while the Reynolds number compares inertial and viscous effects. These are different approximations: low Mach number does not require laminar flow. A fixed probe measures an Eulerian coordinate reading; smoke markers can visualize paths and mixing, with the limitation that their motion must follow the air closely enough for the question being studied.
Asthma Created 2026-10-31 Updated 2026-11-05
Brian L. Graham 2026-11-05
Brian L. Graham is first author of the 2019 official American Thoracic Society and European Respiratory Society statement standardizing spirometry. The document specifies equipment checks, acquisition quality and the definitions used to compare forced expiratory measurements.[ref]
Standardization of Spirometry 2019 Update by Brian L. Graham and others. Title page, primary byline; Equipment and Device Quality Assurance; FVC Maneuver
Standardization connects an instrument's numerical output to a reproducible physiological observation.A basic distinction is between airflow and accumulated expired volume. For a flow-sensing instrument with correct zero and a defined start time,An original flow example takes for , with expressed in seconds. It gives L, about 2.36 L at one second and 5.19 L at four seconds. The model is not a reference human expiratory curve; it illustrates why a time-specific volume and the initial flow rate are different quantities.
If the flow estimate has a constant zero error , integration adds to the volume. A stipulated adds 0.080 L over four seconds even if repeated samples of the same biased flow are very precise. Gain errors and timing errors have different effects and need separate checks.
The primary statement describes spirometer calibration verification with a 3-L syringe at multiple flow rates.[ref]
Standardization of Spirometry 2019 Update by Brian L. Graham and others. Calibration and Quality Control, printed p.e75; Table 3
Testing several delivery rates addresses more than matching one number at one speed. It probes whether the measurement system gives compatible integrated volumes across its specified operating conditions. This is measurement calibration and quality assurance, not a diagnosis from a hypothetical flow curve.Graham's documented contribution is the shared technical framework that makes these observations comparable. Instrument response, zero setting, acquisition quality and quantity definitions remain relevant even when a computer performs the integration automatically.
Laryngeal oedema Created 2026-10-31 Updated 2026-11-05
Lip 2026-11-05
A lip is a movable fold at the entrance to the mouth, with skin externally and oral mucosa internally. The lips contain the orbicularis oris muscle, whose contraction helps close and shape the oral opening. Their sensory supply helps guide contact with food and objects.[ref]
Anatomy and Physiology 2e by J. Gordon Betts and others. Section 23.3, The Mouth: lips, mucosa and orbicularis oris
The oral seal has several functions. During eating it helps retain food; during speech, closure and release can interrupt airflow, while rounding changes the geometry of the vocal tract. A bilabial stop such as /p/ uses contact between both lips, whereas a rounded vowel uses an open but reshaped outlet. The visible fold and the muscle controlling it are related structures, rather than identical anatomical objects.
Ole Storstein 2026-11-05
Ole Storstein is first author of a 1959 experimental study separating airway resistance from lung compliance. The investigators recorded mouth-to-esophageal pressure differences, breathing volume and airflow to analyze the mechanical behavior of respiration.[ref]
Airway Resistance and Lung Compliance by Ole Storstein and others. Primary byline; Methods, simultaneous pressure, volume and airflow recordings
The apparatus used an intra-esophageal balloon, a differential pressure transducer and a pneumotachograph with volume integration. The paper selected corresponding points of no mouth airflow for its compliance calculation and used paired observations during inflation and deflation to estimate resistance.[ref]
Airway Resistance and Lung Compliance by Ole Storstein and others. Methods, Sanborn recording apparatus and definitions of compliance and resistance
Simultaneous signals matter because a pressure observed during flow includes a different mechanical contribution from pressure observed after that flow term vanishes.For an original one-compartment model with a chosen zero-volume baseline, writewhere is lung compliance and is airway resistance. This neglects inertial and regional effects. At stipulated , L, and L/s, the elastic contribution is 4 and the resistive contribution is 1 cm of water. Total modeled pressure is 5 cm of water.
Dividing volume by that total would give , below the chosen compliance. At the same modeled volume and zero flow, pressure becomes 4 cm of water and the ratio recovers 0.10. A time point and the definition of the pressure difference are therefore part of the observable, rather than optional details.
The primary paper explicitly notes the limitation of treating a nonuniform mechanical system as uniform.[ref]
Airway Resistance and Lung Compliance by Ole Storstein and others. Discussion, interpretation of the simplified mechanical analysis
Zero net airflow at the mouth need not establish that every region has identical local behavior. Storstein's documented contribution combines apparatus, simultaneous observations and a stated mechanical interpretation, rather than equating one pressure/volume ratio with every aspect of lung function.The several methods are natural ventilation by wind or buoyancy, mechanical supply, mechanical extraction, and combinations of these. Each must provide both a route for clean outdoor air to enter and a route for used air to leave.
For natural ventilation, opening windows on different sides permits cross ventilation when the wind creates a suitable pressure difference. Even one window can exchange air, but the amount and distribution are more dependent on conditions. Openings at different heights use the stack effect: warmer, less dense indoor air tends to rise and leave through an upper opening, drawing replacement air through a lower one. A flue or ventilating shaft can extend this route. A fireplace may assist extraction through its chimney, provided replacement air enters and combustion products are carried safely away.
Permanent inlets, adjustable window openings and outlet shafts can make these principles more controllable. Their positions should distribute fresh air through the occupied part of the ward instead of allowing it to pass directly from inlet to outlet. An open door into an adjoining foul space is not necessarily a source of clean air. Florence Nightingale's pre-1864 discussions emphasize outside air, openings and the relation between ventilation and warmth; admitting fresh air need not mean exposing a patient to an avoidable cold draught.[ref]
Notes on Nursing by Florence Nightingale. Ventilation and warming
[ref]Notes on Hospitals by Florence Nightingale. Third edition, 1863, discussion of ward ventilation and window arrangements
With mechanical extraction, a fan or other air-moving apparatus removes indoor air, while planned inlets admit replacement air. With mechanical supply, the apparatus introduces outdoor air, and outlets allow displacement of the used air. A balanced installation provides both mechanically. Natural openings can also be combined with mechanical assistance. Heating the incoming air can reduce chilling without making it necessary to recirculate all the used air.
What matters is the actual airflow through the room, including its direction. Outlet flow can be investigated with an anemometer; short-circuiting between nearby openings and stagnant regions must be considered. Moving the same indoor air around does not by itself supply fresh air. Nor does a perfume remove a source of contamination. Source removal, sufficient exchange and reasonable temperature control belong together; windows or fans are means to those ends, not proof that they have been achieved.
Respiratory disease Created 2026-10-31 Updated 2026-11-05
A disorder affecting the respiratory system or its function. Airflow limitation, impaired gas exchange and disturbed control of breathing are different routes to respiratory disability.
Respiratory medicine Created 2026-10-31 Updated 2026-11-05
The branch of medicine concerned with breathing, gas exchange and respiratory disease. Airflow, lung expansion, diffusion and blood flow can each limit respiratory performance through different mechanisms.
Thyroid cartilage 2026-11-05
The thyroid cartilage is the large shield-like cartilage forming much of the anterior and lateral framework of the larynx. Its two broad plates meet at the front, and its connections provide support and attachment for tissues involved in airway protection and voice production.[ref]
Anatomy and Physiology 2e by J. Gordon Betts and others. Section 22.1, Larynx and laryngeal cartilages
Movement at its relationship with the cricoid cartilage helps alter vocal-fold tension. Changing tension changes the mechanical conditions for oscillation, while airflow supplies energy. The cartilage is distinct from the nearby thyroid gland: sharing the word “thyroid” does not make the laryngeal supporting structure a hormone-secreting gland.