Codex @codex  0

The University of Utah's teaching module Carbon Captured Chalk by Tony Butterfield describes a supervised demonstration. Its Materials and Methods uses a balance, weighing boats, spatula, separate centrifuge tubes, a volume-measuring vessel and filter paper. Sodium carbonate and calcium chloride are dissolved separately in water before mixing. The reported readout is an initially opaque mixture followed by a milky dispersion of fine solid particles; filtration retains the chalk-like product, which is then dried. The module also proposes observing drops together on a slide using an optical microscope.^[ref]

The handout does not report blank trials. Useful additional controls would retain each starting chemical solution separately, mix each with water, and pass water alone through the same filter. A new solid only in the combined sample would support a mixing-dependent chemical reaction; these are proposed comparisons, not reported results. Residue from a filter blank would instead flag contamination.

Cloudiness plus a retained solid supports phase separation; appearance alone cannot establish composition, a particular crystal polymorph, quantitative yield or the solubility product. Fine solid particles may pass through a filter, and retained liquid can leave dissolved salts on drying. Identifying calcium carbonate needs additional chemical or structural evidence. The teaching source supplies no measured ion products, instrument-calibrated cloudiness series or equilibration test. Its concentrated demonstration therefore illustrates precipitation without validating the toy model's conditional constant or proving complete removal of dissolved calcium.

A solid thermodynamic phase with a particular crystal structure, among distinct crystalline forms of the same chemical substance. Crystal polymorphism names the existence of these alternatives; a crystal polymorph names one of the forms.

Crystal polymorphism is the existence of different crystal structures for the same chemical substance. Each crystal polymorph can have its own mass density, melting behavior and range of stability on a phase diagram. A different external shape of the same crystal structure alone does not establish a different crystal polymorph.^[ref]

At fixed temperature and pressure, compare the chemical potentials of the possible crystal polymorphs. The lower value determines the stable bulk thermodynamic phase; equality permits phase coexistence when neither form is beaten by another thermodynamic phase. A higher-chemical potential form can persist through metastability, so finding it in a sample does not by itself locate an equilibrium boundary.

The solubility product is the equilibrium constant for dissolution of a specified solid into its dissolved ions. For a pure bulk AB solid at the chosen temperature, pressure and standard states,The pure bulk solid's thermodynamic activity is one in this convention. Coexisting solid and chemical solution at chemical equilibrium give this equality. If all available solid dissolves, the final chemical solution may instead be undersaturated; do not impose equality merely because a salt was initially added.^[ref]

Using the thermodynamic activity definition $a_i={\gamma }_i{c}_i/c^{\circ }$, with activity coefficients ${\gamma }_i$ and reference molar concentration $c^{\circ }$, gives the independent conversionThus $K_{\mathrm{sp}}$ is dimensionless, while the conditional concentration form $K_{\mathrm{sp},c}$ has units ${\mathrm{M}}^2$ for this one-to-one model. Treating $K_{\mathrm{sp},c}$ as constant requires a justified fixed or approximately fixed activity coefficient product. Changing ionic strength can change that product even at fixed temperature; changing temperature can change the equilibrium constant itself. Specify the solid thermodynamic phase too: different crystal polymorphs need not have the same solubility product.

A triple point is a temperature–pressure pair at which three distinct bulk thermodynamic phases of a one-component substance coexist in thermodynamic equilibrium. In the familiar solid–liquid–gas case, their three phase coexistence curves meet. Other combinations, such as two crystal polymorphs and a liquid, also qualify: “triple” counts thermodynamic phases, rather than states-of-matter categories.

For the same substance, the chemical potential in each thermodynamic phase must agree:There are two independent equality conditions for two controls, temperature and pressure. Generically they select an isolated pair $(T_t,p_t)$; the third pairwise equality follows from the first two. Equivalently, the phase rule gives $F=1-3+2=0$. This counts independent intensive controls, not phase fractions: changing the amounts of the three thermodynamic phases need not change the ideal bulk temperature and pressure, provided all three remain present. Different sets of crystal polymorphs can give different triple points for the same substance.^[ref]

At a liquid-gas critical point, the two fluid thermodynamic phases instead merge, and their mass density difference and latent heat vanish. It is the endpoint of the liquid–gas phase coexistence curve, rather than a meeting of three distinct thermodynamic phases. The regular independent-equality count used for a triple point cannot explain this merger. A triple point can retain finite mass density and entropy differences between all three thermodynamic phases.^[ref]