Past exam of the physics 2 paper of the University of Oxford / 2019 / 10

Use complex phasors with time dependence $e^{i\omega t}$ and assume an unloaded output. The capacitor has electrical impedance $Z_C=1/(i\omega C)$. The voltage divider formed with the resistor gives the transfer functionFor input $V_i(t)=V_{i0}\cos \omega t$, the output amplitude and phase shift areso $V_o(t)=|{\tilde{V}}_o|\cos (\omega t-{\tan }^{-1}(\omega RC))$.

Here $\tau =RC=16.0\mu \mathrm{s}$, and the cutoff frequency is $f_c=1/(2\pi RC)=9.947\mathrm{kHz}$. This is an RC low-pass filter: at small frequency the capacitor has large electrical impedance and the output nearly equals the input; at large frequency it increasingly shunts the signal to ground. The amplitude then falls as $1/f$, and the phase shift approaches $-90^{\circ }$.

No numerical input amplitude is supplied, so the output voltages are specified as fractions of $V_{i0}$. An application is suppression of high-frequency electrical noise on a slowly varying signal. A finite load changes the transfer function and must be included if its electrical impedance is comparable with the circuit's output electrical impedance.

For an ideal operational amplifier under negative feedback, the grounded non-inverting terminal makes the inverting terminal a virtual ground, and no electric current enters either input. The feedback resistor and capacitor have parallel electrical impedanceKirchhoff's current law at the inverting node gives ${\tilde{V}}_i/R_1+{\tilde{V}}_o/Z_f=0$, and henceWith the stated components, $R_{2}C=16.0\mu \mathrm{s}$ and $R_2/R_1=5$. Thus this inverting low-pass amplifier has exactly the same ideal cutoff frequency and normalized frequency response as the passive RC low-pass filter, with output multiplied by $-5$:Its amplitude ratios at the three stated frequencies are $4.99975$, $3.52616$, and $0.97560$. One principal choice of phase shift is $180^{\circ }-{\tan }^{-1}(\omega \tau )$: respectively $179.424^{\circ }$, $134.848^{\circ }$, and $101.252^{\circ }$. Adding or subtracting $360^{\circ }$ describes the same output; the extra inversion must be retained.

The passive RC low-pass filter is simple, inexpensive, requires no power supply, and has no operational amplifier saturation or finite bandwidth limitation. It offers no voltage gain; its output impedance is finite, and both source electrical resistance and loading can change the observed frequency response. Its resistor also produces thermal noise.

The active inverting low-pass amplifier provides a low-frequency voltage gain of magnitude five and, within the usable bandwidth, a small output impedance, so it can drive a load with much less change in frequency response. The input electrical resistance is approximately $R_1=1\mathrm{k}\Omega$ and may itself load the source. It needs a power supply and adds electrical noise and offset; finite operational amplifier gain, bandwidth, slew rate, available output swing, and output electric current limit the ideal formula. Its inversion must also suit the application. The best choice depends on required voltage gain, source and load electrical impedances, and the signal's frequency and amplitude.